HP Designjet H45000 HP Designjet H35000 and H45000 Printer Series - Release No - Page 11

Version 1.11 • Aperture settings included - the UV Lamps Apertures settings, omitted from the Media Wizard settings screen in previous versions of the software, now appear on this screen. • Service station vacuum switched off after head motion failure - after a head montion failure, the service station vacuum now shuts off immediately, rather than waiting for the user to press a key on the control panel. • Media Wizard settings for 3M inks - for standard media types, the Media Wizard settings are optimized for 3M inks if 3M profilers are present, to compensate for differences in curing compared to SolaChrome UV inks. Version 1.11 • NEW Service Calibrations - a new menu called Service Calibrations has been added, which contains the head height, service station and media thickness sensor calibrations. Refer to the User Manual Revision C for instructions. • AutoTune message added - when the printer is automatically performing AutoJet calibrations, the control panel displays the message "Performing AutoTune Service." • Wiping during Performance Purge - to extend the service life of the wipers, during a Performance Purge the wipers now wipe in one direction only, and do not maintain contact with the printheads when changing direction. • Clear all bad jets for a head - you can now clear all of the bad jets on a single printhead. This is useful when a printhead is replaced. The existing Clear all bad jets function still clears all of the bad jets on all printheads. Refer to the User Manual Revision C for instructions. (Calibration > Manual Calibrations > Manual Jet Mapping) • Lamps set to low power when carriage is paused during printing - this has been implemented to extend the life of the UV lamps and prevent overheating. • Revision C User Manual - a revised user manual is being released at the same time as this software version. • Various issues resolved, including: • Carriage striking edge guards or platen during auto calibrations - the minimum focus height of the camera (digital imaging sensor) has been raised to avoid this situation. • When a new media type is created with a head height of 0.065 inches, the setting is now saved. • False "Media Out" condition - adjustments have been made to prevent the Input side light-blocking brushes from causing a false Media Out condition. 0706430 Revision M 11