HP Designjet H45000 HP Designjet H35000 and H45000 Printer Series - Release No - Page 7

Version 2.04 Version 2.04 • Top gutter additions, corrections - the factory now enters the printer's serial number into the printer's memory. This enables the serial number to be printed in the top gutter legend of printed output. The direction of printing in unidirectional mode now appears in the top gutter. Sharp Edge mode was being indicated twice in the top gutter; this version removes the second occurrence. • Quality Check failure raises Warning message - if Quality Check is set to "unattended," and a print job fails the Quality Check, the printer now raises the Warning, "W-PC-9 Quality Check Denied a Job." For details, press the info button on the Warning screen. The Warning is not raised if Quality Check is set to "attended," because in this case the printer waits for the user to acknowledge that the job is being rejected. • Lamps can be shuttered in the non-printing direction in unidirectional mode - when setting unidirectional print mode, the printer presents the option to completely shutter the UV lamps in the non-printing direction, or keep them at the same setting as during printing (the default setting). This option reverts to the default if the printer is restarted. • Media thickness can be entered manually - the Media Wizard now allows you to use or not use the media thickness sensor during the media load process. If you choose not to use the sensor, you manually enter the media thickness via the control panel. This value is stored in the Media Wizard settings as in previous versions. • Service Station check - if the service station height is not calibrated, the printhead carriage rail will not lower, and an error message will be displayed on the control panel. • Canceling service station calibrations - you can now cancel the service station calibrations after confirming that the service station is below the platen. The rail will stay at the home position and the carriage will be sent home. • Slow carriage motion test can be skipped - during the Carriage Motion test (Tools > User Diagnostics > Carriage Motion), you can choose to perform or skip the "slow speed motion test." • Camera height calibration warning - after calibrating the head height and media thickness sensor, a reminder to calibrate the camera height now appears on the control panel, and a warning is placed in the Attention queue. • Shutter aperture settings now work when printing in Sharp Edge mode - when a print job was received with Sharp Edge mode enabled, the shutter aperture settings were being ignored if they were different from the settings stored in the Media Wizard. This version uses the settings stored in the print job. • ATTN key no longer pauses printing - pressing the ATTN (Attention) key during printing no longer causes printing to pause. 0706430 Revision M 7