HP Designjet H45000 HP Designjet H35000 and H45000 Printer Series - Release No - Page 9

Version 2.0 • Media leading edge found on the right side - when measuring the media, the leading edge is found on the right side (user end) to avoid overheating the media. • Recovery from carriage motion errors while in Sleep Mode - the printer is now able to recover from carriage motion errors, such as when the cover is raised, that occur during Sleep Mode. • Printhead service during Sleep Mode - the printer now remembers if the printer was in Sleep Mode before an automatic printhead service. If it was, the software returns the printer Sleep Mode after the service is complete. • Side gutters print at correct size - the side gutters now print at a consistent size, regardless of the resolution. • Changing the media advance during printing - when you change the media advance during printing, the amount of change has been reduced to enable more precise adjustments. • Improved UV lamp information page - this information screen on the control panel has been reorganized for clarity. Version 2.0 • NEW Hewlett-Packard splash screen - the Hewlett-Packard logo now appears when the printer embedded software is first started, to reflect the acquisition of MacDermid ColorSpan by Hewlett-Packard Company on November 1, 2007. • NEW Service station calibration controls - the Service Station Calibration screen now provides arrow keys to move the service station up and down, and wipers forward and back, at either of two speeds. This enables you to align them with greater precision. (Front Page > Calibration > Service Calibrations > Service Station Calibration) • NEW Service station vacuum warning - a Warning message appears on the control panel when the user should check the service station vacuum to determine whether it should be emptied of ink, before and after certain printhead maintenance procedures, and whenever the printer has detected that enough ink has been used in printhead maintenance since the last time the vacuum was emptied. • NEW Valid margin checking - the software now verifies that the sum of the right and left margins is less than the width of the media. • NEW Progress bar - a progress bar graph is now displayed on the control panel to report the percentage complete of certain processes: • Printing 0706430 Revision M 9