HP Designjet H45000 HP Designjet H35000 and H45000 Printer Series - Release No - Page 12

Version 1.10 • Printer stuck at "Finishing Job" - to prevent the printer from remaining in the "Finishing Job" state after a job has printed, the control panel will display a Cancel button if an end-of-job indication is not received from the RIP after one minute. If no such indication is received for ten minutes, or if the VideoNet cable connection is lost during this time, the printer will close the connection and go back to the ready state. • Rail moved to home during startup - this has been implemented to ensure that the carriage will not strike the service station or platen during the printer's power-on cycle, and ensure accurate head height positioning. • After a purge & wipe of the printheads is canceled, vacuum is now switched off as expected. • Camera (digital imaging sensor) errors have been reduced. • When reloading media with the optional foot pedal switch, the control panel now properly reports the media status as loaded, and accurately reports the length of the media. • If specified, a print delay is now applied to calibration prints as well as print jobs sent from the RIP. • Lamp current detection has been improved when only one lamp is on. This should ensure better curing when using one lamp. Version 1.10 • Sheet-fed media loading improvements - this version of the embedded software detects when the media drive rollers are down but no media is present, and raises the rollers so that media can be loaded. • Media reload workflow improved - the previous version of the embedded software required the user to press the Proceed key on the control panel after successfully unloading the media prior to reloading a new sheet. This is no longer required by the current version of the software. • Ink counting accuracy - ink counting accuracy has been improved. • Media width reporting accuracy - the media width reported by the control panel was sometimes 0.1 inch (2.5 mm) under the actual width. This has been corrected. • "No current sensed" error - erroneous "No current sensed" Action messages have been corrected. • 3M ink colors shown in gutter message - all 3M ink colors are now reported in the gutter message. The previous embedded software version omitted some of the colors. • Ink dripping on media - ink leftover from a "micropurge" of the printheads, which is designed to keep the inkjets operating reliably, is now serviced (wiped at the service station) before moving the printhead carriage over the media. • Prep for Shipping - this function has been added to the Service menu, to guide you through emptying the heads and flushing them out using a flush bottle, prior to shipping the printer. Version 1.09 • NEW Measure Media Frequency (cut sheet media only) - you now have the option Full Measure only on first load, which measures the first sheet of media using the method selected in Measure Media Type, and subsequent 0706430 Revision M 12