HP Engage 16t User Guide - Page 13

Mounting the monitor head To attach your monitor to a wall using a swing arm or other mounting fixture, follow the steps in this section to safely and securely connect your monitor. IMPORTANT: This monitor supports the VESA industry-standard 100 mm mounting holes. To attach a thirdparty mounting solution to the monitor head, use four 4 mm, 0.7 pitch, and 10 mm long screws. Longer screws might damage the monitor. Be sure that the manufacturer's mounting solution is compliant with the VESA standard and is rated to support the weight of the monitor head. For best performance, use the power and video cables provided with the monitor. NOTE: This apparatus is intended to be supported by a UL-listed or CSA-listed wall-mount bracket. Removing the monitor stand If you decide to use a wall mount instead of the monitor stand that you attached, first remove the stand. IMPORTANT: Before you disassemble the monitor, be sure that the monitor is turned off and all cables are disconnected. 1. Position the monitor facedown on a flat surface covered by protective sheet made of foam or a clean, dry cloth. 2. Press the release button (1) on the stand. 3. Tilt the base of the stand up (2), and slide the tabs (3) out of the recess on the back of the monitor head. 4. Disconnect and remove all cables from the monitor. Attaching the monitor head to a mounting device This section describes how to attach the VESA bracket to the back of the monitor and attach the monitor head to a mounting device. Setting up the monitor 7