HP Engage 16t User Guide - Page 21
Support and troubleshooting, Solving common issues
View all HP Engage 16t manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 21 highlights
3 Support and troubleshooting If your monitor is not working as expected, you might be able to resolve the issue by following the instructions in this section. Solving common issues The following table lists possible issues, the possible cause of each issue, and the recommended solutions. Table 3-1 Common issues and solutions Issues Possible cause Solution Screen is blank or video is blinking. Power cord is disconnected. Monitor is off. Connect the power cord. Press the monitor power button. NOTE: If pressing the power button has no effect, press and hold the power button for 10 sec to disable the Power Button Lockout feature. Video cable is improperly connected. Connect the video cable properly. For more information, see Connecting the cables on page 8. Image appears blurred, indistinct, or too dark. System is in Auto-Sleep Mode. Monitor is in Power Saver mode. Video card is incompatible. Brightness setting is too low. Press any key on the keyboard or move the mouse to inactivate the screen blanking utility. Change the monitor Power Mode setting from Power Saver mode to Performance mode. For more information, see Changing the Power Mode setting on page 13. Open the OSD menu and select the Input menu. Set AutoSwitch Input to Off and manually select the input. or Replace the video card or connect the video cable to one of the computer's on-board video sources. Open the OSD menu, and select Brightness+ to adjust the brightness scale as needed. "Check Video Cable" is displayed on the screen. Monitor video cable is disconnected. Connect the appropriate video signal cable between the computer and monitor. Be sure that the computer power is off while connecting the video cable. "Input Signal Out of Range" is Video resolution and/or refresh rate displayed on screen. are set higher than the monitor supports. Change the settings to a supported setting Preset display resolutions on page 19. The monitor does not enter The monitor's power saving control is Open the OSD menu and select Power, select Auto-Sleep into a low-power sleep state. disabled. Mode, and then set auto-sleep to On. "OSD Lockout" is displayed. The monitor's OSD Lockout function is enabled. Press and hold the Menu button for 10 seconds to disable the OSD Lockout function. "Power Button Lockout" is displayed. The monitor's Power Button Lockout Press and hold the Power button for 10 seconds to unlock the feature is enabled. power button function. Solving common issues 15