HP Engage 16t User Guide - Page 14
Connecting the cables, IMPORTANT
View all HP Engage 16t manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 14 highlights
1. Position the monitor head facedown on a flat surface covered by protective sheet made of foam or a clean, dry cloth. 2. NOTE: The cables must be connected to the monitor rear panel connectors before you attach the VESA bracket. Attach the VESA bracket to the back of the monitor by inserting the tabs on the top of the mounting plate into the recess on the back of the monitor head (1). 3. Rotate the VESA bracket down until it snaps at the bottom of the recess (2). 4. To attach the monitor head to a swing arm or other mounting device, insert four mounting screws through the holes on the mounting device and into the VESA screw holes on the back of the monitor head. IMPORTANT: If these instructions do not apply to your device, then follow the mounting device manufacturer's instructions when mounting the monitor to a wall or swing arm. Connecting the cables The monitor features a USB Type-C connector and a DisplayPort connector to use as video connection options. ▲ Connect a video cable. NOTE: The cables must be connected to the monitor rear panel connectors before you attach the stand. ● You can route a USB Type-C cable through the stand and attach one end to the USB Type-C connector on the rear of the monitor and the other end to the USB Type-C connector on the source device (1). Then connect one end of the power cord to the AC adapter (2) and the other end to a grounded AC outlet (3). 8 Chapter 1 Getting started