HP Integrity Superdome 2 16-socket HP Superdome 2 Partitioning Administrator G - Page 51
Getting a Console Using the CLI, vPar Virtual Devices tab
View all HP Integrity Superdome 2 16-socket manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 51 highlights
Figure 6-5 vPar Virtual Devices tab 3. Navigate to the status tab to see the run state of the partition. Figure 6-6 Active/vPars Mode State of an nPartition Figure 6-7 Active/EFI prompt State of vPar Getting a Console Using the CLI To access a partition's system console using the command line, run the CO command. It can be used either with or without the partition's ID as shown in the following example: co Booting to EFI and Preparing for Operating System Installation 51
Figure 6-5 vPar Virtual Devices tab
3.
Navigate to the status tab to see the run state of the partition.
Figure 6-6 Active/vPars Mode State of an nPartition
Figure 6-7 Active/EFI prompt State of vPar
Getting a Console Using the CLI
To access a partition’s system console using the command line, run the
CO
command. It can be
used either with or without the partition’s ID as shown in the following example:
co
Booting to EFI and Preparing for Operating System Installation
51