HP J7934G HP Jetdirect Administrator's Guide - Page 205

Configuration Page Messages HP Jetdirect Configuration/General Information Information in this section provides general HP Jetdirect print server configuration as described in Table 9.1. For error messages, see Table 9.11. Table 9.1 HP Jetdirect Configuration (1 of 2) Message Description STATUS: Current state of the HP Jetdirect print server. I/O CARD READY, or READY: The HP Jetdirect print server has successfully connected to the network and is awaiting data. I/O CARD INITIALIZING, or INITIALIZING: The HP Jetdirect print server is initializing the network protocols. For more information, see the status line for each protocol on the configuration page. I/O CARD NOT READY, or ERROR: There is a problem with the print server or its configuration. An error code and message is displayed if the print server is not ready. For more information, see Table 9.11. MODEL NUMBER: The model number of the HP Jetdirect print server (for example, J7951A) HARDWARE ADDRESS: The 12-digit hexadecimal network hardware (MAC) address of the HP Jetdirect print server installed in the printer or device. This address is assigned by the manufacturer. FIRMWAREVERSION: The firmware revision number of the HP Jetdirect print server currently installed in the printer. NETWORK (ew2400) Specifies the type of network connection: CONNECTION TYPE Wireless or Wired. DATA RATE DETECTED (ew2400) Specifies the network data rate depending on the type of network connection: 1 - 54 Mbps (Wireless 802.11g) 10 Mbs, 100 Mbps (Wired 10/100Base-TX) LINK CONFIG (ew2400) Specifies the active link communication mode: 802.11: Wireless 802.11g 10T HALF: 10 Mbps, half-duplex (wired port) 10T FULL: 10 Mbps, full-duplex (wired port) 100TX HALF: 100Mbps, half-duplex (wired port) 100TX FULL: 100Mbps, full-duplex (wired port) ENWW HP Jetdirect Configuration Page 205