HP Pro 3085 Maintenance & Service Guide: HP Pro 3005/3015/3085 Business PC - Page 69
Installing an Internal 3.5-inch Hard Drive, Installing the Hard Drive in the Drive Cage
View all HP Pro 3085 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 69 highlights
Installing an Internal 3.5-inch Hard Drive 1. Follow the steps in Removing an Internal 3.5-inch Hard Drive on page 57 to remove the hard drive cage and, if necessary, the existing hard drive. 2. Slide the new drive into the hard disk drive cage (1), aligning the drive with the four screw holes on the cage. Install the four 6-32 standard screws that secure the hard disk drive to the hard disk drive cage (2). Make sure the hard disk drive cables are facing the top of the drive cage. NOTE: If you are replacing an old drive with a new drive, use the four retainer screws from the old drive to install the new drive. NOTE: If you are installing a second hard drive, use four of the extra standard 6-32 screws that are installed on the interior of the front bezel. The 6-32 screws are silver. Refer to Installing Additional Drives on page 50 for an illustration of the retainer screws location. Figure 6-30 Installing the Hard Drive in the Drive Cage Drives 61