HP Rp3000 HP Cash Drawer for Point of Sale System User Guide - Page 11
Replacing the Inner Drawer, Removing the Case
UPC - 884420494096
View all HP Rp3000 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 11 highlights
Replacing the Inner Drawer 1. Align the outer slides (mounted to the inner drawer) with the inner slides mounted to the chassis inside the cash drawer. 2. Lift the inner drawer up until it stops and begin to push the inner drawer into the cash drawer housing. 3. When the drawer stop on the back of the inner drawer has cleared the stop plate (3) formed from the base, let the inner drawer rest in the horizontal position. 4. Push the inner drawer to the fully closed position. Expect resistance to the insertion because the ball bearings do not roll until the slides are fully engaged. 5. When the inner drawer is fully inserted, verify that the drawer opens and closes properly using the security key. The drawer should open and close smoothly through the full extent of the slides. Removing the Case NOTE: It is recommended that the case be removed only in emergencies, such as when the cash drawer cannot be opened electronically and/or the security key is locked inside the cash drawer. 1. Turn the cash drawer bottom side up with the drawer front opening toward you. 2. Using a #2 Phillips screwdriver, remove the screws securing the base to the case, then slide the base assembly out towards the front. 3. Remove the till and inner drawer from the cash drawer. 4. Replace the base by reinserting it from the front of the case and under the case side flanges. Engage the base with the tabs at the rear of the case. 5. Reattach the base and case with the screws. Be sure the drawer front is lined up with the front edge of the case. Replacing the Inner Drawer 5