HP StorageWorks 16-EL Fabric OS V3.1.1C Release Notes - Page 12

Documentation addendum Documentation addendum Please note the following changes in the documents listed: HP StorageWorks ISL Trunking Version 3.1.x/4.1.x User Guide Please change the following bulleted item, which appears on page 17, from: ■ If Extended Fabrics is in use, the ports must be in the "L0" mode. ISL Trunking does not support the "LE", "L1", or "L2" portcfglongdistance modes. For information about these modes and Extended Fabrics in general, refer to the HP StorageWorks Extended Fabric Version 3.1.x/4.1.x User Guide. to: ■ If Extended Fabrics is in use, the ports must be in the "L" mode. ISL Trunking is supported for normal E_Ports (referred to as "L0" in the portcfglongdistance command) with LWL media up to 5 km at the full speed permitted by the link. With LWL media, the throughput begins to fall off beyond 5 km, due to normal latency effects. ISL Trunking does not support the "LE", "L1", or "L2" portcfglongdistance modes. For information about these modes and Extended Fabrics in general, refer to HP StorageWorks Extended Fabric Version 3.1.x/4.1.x User Guide. HP StorageWorks Fabric OS Procedures Version 3.1.x/4.1.x User Guide Please add the following note after Step 7 on page 81: Note: When the v4.1.x firmware is unzipped, it creates a folder and a set of firmware files. Use the following directory and file name when downloading this firmware to the switch: /v4.1.x/release.plist. For the User prompt, enter a User ID that has an account on the FTP server. 12 Fabric OS 3.1.1c Release Notes