HP StorageWorks 2/32 Brocade Access Gateway Administrator's Guide - Supporting - Page 47
Troubleshooting, Table C-1, Problem, Cause, Solution
View all HP StorageWorks 2/32 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 47 highlights
Troubleshooting Appendix C This appendix provides trouble shooting instructions. Table C-1 Troubleshooting Problem Cause Switch is not in Switch is in Native switch mode Access Gateway mode Solution 1. Disable switch using the switchDisable command. 2. Enable Access Gateway mode using the ag --modeenable command. Answer yes when prompted; the switch reboots. NPIV disabled on edge switch ports Inadvertently turned off 3. Log in to the switch. 4. Display the switch settings using the switchShow command. Verify that the field switchMode displays Access Gateway Mode. 1. On the edge switch, enter the portCfgShow command. 2. Verify that NPIV status for the port to which Brocade Access Gateway is connected is ON. 3. If the status displays as "--" NPIV is disabled. Enter the portCfgNpivPort command with the 1 operand to enabled NPIV. Need to reconfigure N_Port and F_Ports Default port setting not adequate for customer environment 4. Repeat step 3 for each port as required. 1. On Brocade Access Gateway, enter the portCfgShow command. 2. For each port that is to be activated as N_port, enter the portCfgNport command with the 1 operand. All other ports remain as F_port. 3. To reset to the port to an F_port, enter the portCfgNpivPort command with the 0 operand. Access Gateway Administrator's Guide C-1 Publication Number: 53-1000430-01