HP StorageWorks 4/16 Brocade Fabric OS Message Reference Supporting Fabric OS - Page 144

12 EM-1062 Recommended Action Please remove all blades of this type or upgrade your standby CP. Once an appropriate action is taken, this CP must be rebooted or haSyncStart must be run successfully. Until this is done, the system will remain out of synchronization. Severity WARNING EM-1062 Message , [EM-1062], ,, CRITICAL, , Blade in slot faulted as it exceeds the maximum support limit of blades with Blade ID in the chassis. Probable Cause Too many blades of a particular type are in the system. Recommended Remove the faulted blade. Action Severity CRITICAL EM-1063 Message , [EM-1063], ,, CRITICAL, , Blade in slot faulted because it exceeds the maximum support limit of blades with Blade IDs in the chassis. Probable Cause Too many blades of a set of particular types are in the system. Recommended Remove the faulted blade. Action Severity CRITICAL EM-1064 Message , [EM-1064], ,, CRITICAL, , Blade: is being powered off (based on user configuration) upon receiving a HW ASIC ERROR, reason:. Probable Cause The blade is power off since a hardware (HW) application specific integrated circuit (ASIC) ERROR was detected, and the user has selected to power off the problem blade when such a condition occurred. Recommended Contact support. Action Severity CRITICAL 92 Fabric OS Message Reference 53-1000600-01