HP StorageWorks 4/32 Brocade Fabric OS Message Reference guide v6.2.0 (53-1001 - Page 123
BM System Messages, BM-1001
View all HP StorageWorks 4/32 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 123 highlights
BM System Messages Chapter 7 BM-1001 Message , [BM-1001], ,, ERROR, , BM protocol version in slot . Probable Cause Indicates the firmware running on the control processor (CP) cannot communicate with the application processor (AP) blade in the indicated slot and determine the AP blade's firmware version. • The CP blade is running a later version than the AP blade. • The CP blade is running a much older version than the AP blade. Recommended Action The problem can be corrected by changing the firmware version on either the control processor (CP) or on the application processor (AP) blade. The firmware version on the CP blade can be changed using the firmwareDownload command. Refer to the release notes to determine whether a non-disruptive firmware download is supported between the versions. As the AP and CP blades cannot communicate, it is not possible to load new firmware on the AP blade. If needed, send the AP blade back to the factory for a firmware update. Severity ERROR BM-1002 Message , [BM-1002], ,, INFO, , Connection established between CP and blade in slot . Probable Cause Indicates the control processor (CP) has established a connection to the blade processor (BP) and can communicate. Recommended No action is required. Action Severity INFO BM-1003 Message Probable Cause , [BM-1003], ,, WARNING, , Failed to establish connection between CP and blade in slot . Faulting blade. Indicates the control processor (CP) could not establish a connection to the blade processor (BP) to communicate. Fabric OS Message Reference 65 53-1001157-01