HP StorageWorks 8/80 HP StorageWorks Fabric OS 6.1.0c release notes (5697-7680 - Page 15

Closed defect summary Solution During constant power-cycle test, one of the switches panicked due to a memory allocation failure. Fixed in Fabric OS 6.1.0 Request change to parameters passed to Java running on the PC. Fixed in Fabric OS 6.1.0 When ports are segmented, two B-model fabrics are shown connected to each other even though safe zoning state differs. Fixed in Fabric OS 6.1.0 Subnetted FCIP port sends MAC level broadcast instead of the routers MAC. Fixed in Fabric OS 6.1.0 In some cases, frame loss is observed during normal FICON I/O. Fixed in Fabric OS 6.1.0 TopTalkers counters are inaccurate when enabled on more than one Fx_port at a time. Fixed in Fabric OS 6.1.0 Top Talker F_Port monitor is broken, only one F_port can be monitored at one switch. Same test case passed on Beta frame. Fixed in Fabric OS 6.1.0 FICON Emulation Error running to STK/SUN tape drives. Fixed in Fabric OS 6.1.0 An "ipfilter --transabort" command running in one telnet session can be aborted from another telnet session. Fixed in Fabric OS 6.1.0 Cannot set "Portlog events enable" accurately. Fixed in Fabric OS 6.1.0 The DC Director may ASSERT in a specific test scenario while running a particular FICON test program (SAK IRNDUP). Fixed in Fabric OS 6.1.0 Brocade 4Gb SAN Switch for HP c-Class BladeSystem power-on-self-test (POST) failure on chassis power on. Fixed in Fabric OS 6.1.0 Flooding of an unknown inter-switch FDMI command from another vendor's switch is causing the switch to crash. Fixed in Fabric OS 6.1.0 DC Director port blades are re-initialized during supportsave. Fixed in Fabric OS 6.1.0 2Gb Channels fail to come online from T-Rexx mainframe to a 128-port 4/256 SAN Director. Fixed in Fabric OS 6.1.0 Occasional kernel panic during reboot in AG setup. Fixed in Fabric OS 6.1.0 Under very rare conditions, and in a configuration where there are multiple paths configured to reach multiple devices, some paths were Fixed in Fabric OS 6.1.0 observed not coming online. During fastwrite, a 3rd party device drops a status frame due to data alignment. Fixed in Fabric OS 6.1.0 HaFailover not working after upgrading firmware from Fabric OS 5.0 to 5.2.0a using firmrwaredownload -s on each CP. Fixed in Fabric OS 6.1.0 Heart beat missing being reported by CP - Standby CP reboots. Fixed in Fabric OS 6.1.0 FICON Virtual Tape Pipelining does not function correctly with specific tape devices. Fixed in Fabric OS 6.1.0 Blade fault does not result in LIRR and async status. Fixed in Fabric OS 6.1.0 Firmware upgrade on 4/8 SAN Switch and 4/16 SAN Switch to Fabric OS 6.0.0 will cause the switch to report marginal state. Fixed in Fabric OS 6.1.0 CUP Set Offline inline command not presenting status before going offline. Fixed in Fabric OS 6.1.0 Usability: Ctrl-C in legacy configdownload code is not blocked during downloads. Fixed in Fabric OS 6.1.0 Switch faults if Management Server Domain is invalid, limited commands available. Fixed in Fabric OS 6.1.0 HP StorageWorks Fabric OS 6.1.0c release notes 15