HP StorageWorks 8/80 HP StorageWorks Fabric OS 6.1.0f release notes (5697-7837 - Page 20

Closed defect summary Solution FIPS related changes required in response to a FIPS audit. Fixed in Fabric OS 6.1.0 SRDFA suspends in a fast-write environment. Fixed in Fabric OS 6.1.0 A device disappears after server reboot in a FICON environment. Fixed in Fabric OS 6.1.0 FC4-48 blade drops frame on the 4/256 SAN Director on ports that are routed through Director ports above 256. Fixed in Fabric OS 6.1.0 IBM FICON Qual. The FW message needs to specify the blade number when a port blade faults in the DC Director.. Fixed in Fabric OS 6.1.0 porttest not working. Fixed in Fabric OS 6.1.0 Need to add a delay to the PLOGI ACCept for all well known addresses. Fixed in Fabric OS 6.1.0 Operator-disabled ports are displayed as marginal under specific conditions. Fixed in Fabric OS 6.1.0 firmwaredownload pre-install script fails to detect that QOS links are active prior to a downgrade. Fixed in Fabric OS 6.1.0 Phantom power supply faults logged against the DC Director. Fixed in Fabric OS 6.1.0 Power supply status incorrectly identified as marginal when power supplies are in certain slots. Fixed in Fabric OS 6.1.0 The switch status is shown as Healthy with one core blade even when the policy is set to show as marginal on removal/failure of a core Fixed in Fabric OS 6.1.0 blade. FICON Tape Pipelining with specific tape devices results in block count mismatch errors. Fixed in Fabric OS 6.1.0 A DC Director might erroneously report a failed attempt at reading a temperature sensor as -1° Celsius. Fixed in Fabric OS 6.1.0 On an FR4-48 with FMS enabled, duplicate port names for some ports that share the same address. Fixed in Fabric OS 6.1.0 IFCCs caused by incorrect positioning for FICON Read Tape Pipelining. Fixed in Fabric OS 6.1.0 Management server GMAL command is being rejected with reason 5, Logical Busy. Fixed in Fabric OS 6.1.0 FCIP Compression enhanced to take advantage of higher compression rates. Fixed in Fabric OS 6.1.0 20