HP StorageWorks 8/80 HP StorageWorks Fabric OS 6.1.0f release notes (5697-7837 - Page 21

Fabric OS 6.1.0a - base san switch

Get HP StorageWorks 8/80 - SAN Switch PDF manuals and user guides View all HP StorageWorks 8/80 manuals
Add to My Manuals
Save this manual to your list of manuals

Page 21 highlights

Fabric OS 6.1.0a fixes Table 7 lists defects closed in the Fabric OS 6.1.0a firmware release. Table 7 Fabric OS 6.1.0a closed defects Closed defect summary Solution Under rare conditions, fabric mode TopTalker monitor does not display correct flow values. Fixed in Fabric OS 6.1.0a Attempting to configure port mirroring on a director with both 4-Gb and 8-Gb blades may result in a software Verify error. Fixed in Fabric OS 6.1.0a After repeatedly running bladedisable/enable on one FC8-48 blade for six hours, a DC Director panics. Fixed in Fabric OS 6.1.0a FCR matrix settings may not persist after hafailover on a 4/256 SAN Director. Fixed in Fabric OS 6.1.0a When disabling/enabling a port, Port Fencing disables the port because the allowable number of invalid transmission words is exceeded. Fixed in Fabric OS 6.1.0a Under rare conditions, a DC Director panics during SAK IRNDUP when the software watchdog detects an unexpected termination of the FICON CUP daemon (ficud). Fixed in Fabric OS 6.1.0a Port Based Routing with DLS ON does not immediately balance the load when adding an ISL. Fixed in Fabric OS 6.1.0a Ex_Port fails to come online after downgrading firmware from Fabric OS 6.x to 5.3 under certain conditions. Fixed in Fabric OS 6.1.0a Fastwrite performance issue with a particular FCIP ex-port configuration. Fixed in Fabric OS 6.1.0a During storage failover/failback test with IP over FC, traffic stops and fails to recover in single and dual backbone configurations. Fixed in Fabric OS 6.1.0a During non-disruptive firmwaredownload, Ex_Ports may toggle, causing traffic disruption in a 8/40 SAN Switch and 8/80 SAN Switch. Fixed in Fabric OS 6.1.0a After hareboot, "Probing failed" on F_Port messages may be seen on the 8/8 SAN Switch, 8/24 SAN Switch, 8/40 SAN Switch or 8/80 SAN Switch. Fixed in Fabric OS 6.1.0a Under rare conditions, ISL may get stuck at G_Port on the 8/8 SAN Switch, 8/24 SAN Switch or 8/80 SAN Switch. Fixed in Fabric OS 6.1.0a Launching Switch Throughput graph in Advanced Performance Monitor for the 8/8 SAN Switch, 8/24 SAN Switch, 8/40 SAN Switch or 8/80 SAN Switch. Throughput graph will not display 8G/sec values. Fixed in Fabric OS 6.1.0a On a 8/80 SAN Switch, the system status LED does not flash amber/green when a power supply is faulted. The system status LED remains steady green. Fixed in Fabric OS 6.1.0a HP StorageWorks Fabric OS 6.1.0f release notes 21

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
Fabric OS 6.1.0a
fi
xes
Table 7
lists defects closed in the Fabric OS 6.1.0a
fi
rmware release.
Table 7 Fabric OS 6.1.0a closed defects
Closed defect summary
Solution
Under rare conditions, fabric mode TopTalker monitor does not
display correct
fl
ow values.
Fixed in Fabric OS 6.1.0a
Attempting to con
fi
gure port mirroring on a director with both 4-Gb
and 8-Gb blades may result in a software
Verify
error.
Fixed in Fabric OS 6.1.0a
After repeatedly running
bladedisable
/
enable
on one FC8-48
blade for six hours, a DC Director panics.
Fixed in Fabric OS 6.1.0a
FCR matrix settings may not persist after
hafailover
on a 4/256
SAN Director.
Fixed in Fabric OS 6.1.0a
When disabling/enabling a port, Port Fencing disables the port
because the allowable number of invalid transmission words is
exceeded.
Fixed in Fabric OS 6.1.0a
Under rare conditions, a DC Director panics during SAK IRNDUP
when the software watchdog detects an unexpected termination of
the FICON CUP daemon (
ficud
).
Fixed in Fabric OS 6.1.0a
Port Based Routing with DLS ON does not immediately balance the
load when adding an ISL.
Fixed in Fabric OS 6.1.0a
Ex_Port fails to come online after downgrading
fi
rmware from Fabric
OS 6.x to 5.3 under certain conditions.
Fixed in Fabric OS 6.1.0a
Fastwrite performance issue with a particular FCIP ex-port
con
fi
guration.
Fixed in Fabric OS 6.1.0a
During storage failover/failback test with IP over FC, traf
fi
c stops and
fails to recover in single and dual backbone con
fi
gurations.
Fixed in Fabric OS 6.1.0a
During non-disruptive
firmwaredownload
, Ex_Ports may toggle,
causing traf
fi
c disruption in a 8/40 SAN Switch and 8/80 SAN
Switch.
Fixed in Fabric OS 6.1.0a
After hareboot, "Probing failed" on F_Port messages may be seen
on the 8/8 SAN Switch, 8/24 SAN Switch, 8/40 SAN Switch or
8/80 SAN Switch.
Fixed in Fabric OS 6.1.0a
Under rare conditions, ISL may get stuck at G_Port on the 8/8 SAN
Switch, 8/24 SAN Switch or 8/80 SAN Switch.
Fixed in Fabric OS 6.1.0a
Launching Switch Throughput graph in Advanced Performance
Monitor for the 8/8 SAN Switch, 8/24 SAN Switch, 8/40 SAN
Switch or 8/80 SAN Switch. Throughput graph will not display
8G/sec values.
Fixed in Fabric OS 6.1.0a
On a 8/80 SAN Switch, the system status LED does not
fl
ash
amber/green when a power supply is faulted. The system status
LED remains steady green.
Fixed in Fabric OS 6.1.0a
HP StorageWorks Fabric OS 6.1.0f release notes
21