HP StorageWorks 8/80 HP StorageWorks Fabric OS 6.2.0d release notes (5697-0353 - Page 27
Updated command message, Gb SAN Switch for HP, BladeSystem c-Class, All 8-Gb switches except 8-Gb
View all HP StorageWorks 8/80 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 27 highlights
Table 6 portcfgfillword command summary Fabric OS version All 8-Gb switches (except 8-Gb 8-Gb SAN Switch for HP SAN Switch for HP BladeSystem BladeSystem c-Class c-Class) All ports set to idles. No arb(ff) Any Fabric OS earlier than 6.1.2 capability existed. 1 All ports set to idles. No arb(ff) capability existed. 2 FOS 6.2.0x prior to 6.2.0c Arb(ff) by default on all ports and can't be changed. All ports default to arb(ff) (internal and external) and can't be changed. 6.1.2x and 6.2.0c and later (HP Added the ability to change portcfg- Added the ability to change portcfg- did not support 6.2.0c) fillword to idle or arb(ff). 1 fillword to idle or arb(ff). 2 6.1.2x and 6.2.0d through 6.2.x All ports default to idle [mode 0] regardless of what FOS was previously installed, unless manually changed to arb(ff) previously [mode 1], then it will remain arb(ff). Can be changed by the user. • If 6.2.0d was installed in the factory, all internal ports remain at arb(ff) [mode 1], external ports at idle [mode 0]. Can be changed by the user. • If pre-6.2.0d was installed in the factory, all internal and external ports remain at idle [mode 0], unless they were manually changed to arb(ff) [mode 1], then they remain at arb(ff). Can be changed by the user. Mode: 0-IDLE for Link Init, IDLE for fill word 1-ARB(FF) for Link Init, ARB(FF) for fill word (NOTE: not supported with XP storage arrays) 16.1.2x was not supported on EVA4400 embedded switch module. 26.1.2x was not supported on this switch. Updated command message When executing the lscfg --create command using the following syntax, the message that followed before the FW upgrade was: nl switch_128:FID128:admin> lscfg --create 1 nl About to create switch with fid=1. Please wait... Logical Switch with FID (1) has been successfully created. The new message has changed to: Logical Switch has been created with default configurations. Please configure the Logical Switch with appropriate switch and protocol settings before activating the Logical Switch HP StorageWorks Fabric OS 6.2.0d release notes 27