HP StoreOnce 4430 HP StoreOnce Backup System Concepts and Configuration Guidel - Page 38
Template 2, uses 1GbE network only, The default bonding mode for this template is Mode 6
View all HP StoreOnce 4430 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 38 highlights
The default bonding mode for this template is Mode 1, Active/Backup, on both sub-nets. The recommended IP address range is 25 in total: 16 contiguous on the data sub-net; 1 + 8 contiguous on the management sub-net. NOTE: When using a 10GbE network, you must provide the correct SFPs for your environment. They are not supplied with the product. Figure 16 Template 1 cabling to customer's networks 1 and 2 3 and 4 blue cables blue cables bonded 10 GbE ports, normally to customer's data sub-net bonded 1 GbE ports, normally to customer's management sub-net internal cabling, should not be removed internal cabling, should not be removed Template 2, uses 1GbE network only Template 2 supports users who have a 1GbE network only. The same network is used for data and management. The default bonding mode for this template is Mode 6, Active Load Balancing. The recommended IP address range is 17 in total: 1 for management and 16 contiguous for data. NOTE: For software revision 3.3.0 and greater: customers who do not have a sufficient number of physical Ethernet ports to support Template 2 should use Template 5 instead. Figure 17 Template 2 cabling to customer's networks 1, 2, 3 and 4 blue cables bonded 1 GbE ports to customer's data and management network internal cabling, should not be removed 38 Network configuration in multi-node StoreOnce Backup systems