HP StoreOnce 4430 HP StoreOnce Backup System Concepts and Configuration Guidel - Page 39
Template 3, uses 10GbE network only, uses two 1GbE networks
View all HP StoreOnce 4430 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 39 highlights
Template 3, uses 10GbE network only Template 3 supports users who have a 10GbE network only. The same network is used for data and management. The default bonding mode for this template is Mode 1, Active/Backup. The recommended IP address range is 17 in total: 1 for management and 16 contiguous for data. NOTE: When using a 10GbE network, you must provide the correct SFPs for your environment. They are not supplied with the product. Figure 18 Template 3 cabling to customer's networks 1 and 2 blue cables bonded 10 GbE ports to customer's data and management network internal cabling, should not be removed Template 4, uses two 1GbE networks Template 4 supports users who have two 1GbE networks. One 1 GbE network is used for data; the other is used for management. The gateway must be in the same sub-net as the network that is being used to connect to remote sites. This is normally the data path sub-net, for example used for remote/external site replication traffic. The default bonding mode for this template is Mode 1, Active/Backup, on both sub-nets. The recommended IP address range is 25 in total: 16 contiguous on the data sub-net; 1 + 8 contiguous on the management sub-net. Figure 19 Template 4 cabling to customer's networks 1 and 3 2 and 4 light blue cables bonded 1 GbE ports to customer's management sub-net bonded 1 GbE ports to customer's data sub-net internal cabling, should not be removed Supported network configurations (templates) 39