HP t505 Hardware Reference Guide t505 Flexible Thin Client - Page 18

Installing Thin Client Options, Removing and Replacing the Battery

Get HP t505 PDF manuals and user guides View all HP t505 manuals
Add to My Manuals
Save this manual to your list of manuals

Page 18 highlights

Installing Thin Client Options Various options can be installed on the thin client: ● Removing and Replacing the Battery on page 12 ● External Drives on page 13 Removing and Replacing the Battery Before beginning the replacement process, review General Hardware Installation Sequence on page 9 for procedures you should follow before and after installing or replacing hardware. WARNING! Before removing the side access panel, ensure that the thin client is turned off and the power cord is disconnected from the electrical outlet. To remove and replace the battery: 1. Locate the battery on the system board. 2. To release the battery from its holder, squeeze the metal clamp that extends above one edge of the battery. When the battery pops up, lift it out (1). Figure 2-2 Removing and replacing the internal battery 3. To insert the new battery, slide one edge of the replacement battery under the holder's lip with the positive side up (2). Push the other edge down until the clamp snaps over the other edge of the battery. HP encourages customers to recycle used electronic hardware, HP original print cartridges, and rechargeable batteries. For more information about recycling programs, go to http://www.hp.com/ go/recycle. Batteries, battery packs, and accumulators should not be disposed of together with the general household waste. In order to forward them to recycling or proper disposal, please use the public collection system or return them to HP, an authorized HP partner, or their agents. 12 Chapter 2 Hardware Changes

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
  • 40
  • 41
  • 42
  • 43
  • 44
Installing Thin Client Options
Various options can be installed on the thin client:
●
Removing and Replacing the Battery
on page
12
●
External Drives
on page
13
Removing and Replacing the Battery
Before beginning the replacement process, review
General Hardware Installation Sequence
on page
9
for procedures you should follow before and after installing or replacing hardware.
WARNING!
Before removing the side access panel, ensure that the thin client is turned off and the
power cord is disconnected from the electrical outlet.
To remove and replace the battery:
1.
Locate the battery on the system board.
2.
To release the battery from its holder, squeeze the metal clamp that extends above one edge of
the battery. When the battery pops up, lift it out (1).
Figure 2-2
Removing and replacing the internal battery
3.
To insert the new battery, slide one edge of the replacement battery under the holder’s lip with the
positive side up (2). Push the other edge down until the clamp snaps over the other edge of the
battery.
HP encourages customers to recycle used electronic hardware, HP original print cartridges, and
rechargeable batteries. For more information about recycling programs, go to
go/recycle
.
Batteries, battery packs, and accumulators should not be disposed of together with the general household
waste. In order to forward them to recycling or proper disposal, please use the public collection system or
return them to HP, an authorized HP partner, or their agents.
12
Chapter 2
Hardware Changes