Hitachi 32PD7800 Owners Guide - Page 49

ENGLISH OTHER FUNCTIONS (continued) DVD Player/STB Selection (continued) Set up hint Example) HITACHI DVD ᕃ To operate HITACHI DVD player, press and hold the button, followed by the ᕃ button. 1. Press button to indicate the lamp of DVD on the remote control. During LED lighting, press and ᕃ to set up the maker. 2. Release the ᕃ button once while keeping button, press the ᕃ button again to set the maker type. * After set up the maker type, press the button related with DVD, and make sure that DVD player is working. In case DVD player does not work, repeat 1 and 2 with other numbers for the maker type to make sure it. (In this example, press ᕄ or ᕅ.) NOTE • Not all models of the listed makers can be operated using this remote control. Signal Check (RGB mode) Changes in the signal status are displayed on the screen as they arise. Status Display When Mode Display is set to ON, the input signal is switched or when the RECALL button is pressed. A guide is displayed for the input terminal and the horizontal and vertical sync frequency. Action When the sync signal is no longer detected. When the input signal does not match the monitor specifications or is in an unstable status. • A guide displays No Sync. Signal, and Power Save (for approx. 5 sec.) • When the condition continues where the sync signal cannot be detected, indicator lamp of power source changes in orange and the mode switches to power save mode. A guide displays Invalid Scan Freq. Recheck the personal computer power switch status and the connection status. Recheck the input signal specifications. 54 ~ 57 RGB OFF -- -- Min RGB2 RGB H : 48.4kHz V : 60.1 Hz ! No Sync. Signal ! Invalid Scan Freq. 49