Hitachi CMP307XU Owners Guide - Page 12

ENGLISH INSTALLATION INSTRUCTIONS (continued) Handling the Remote Controller Loading Batteries (1) Open the battery cover. Slide the battery cover towards the arrow mark while pressing it. (2) Load batteries. Load two Size AA batteries included observing the correct polarities. When replacing the batteries, always use the R6P AA (or SUM-3) type. (3) Close the battery cover. Slide back the battery cover towards the arrow mark. Handling the Remote Controller Use the remote controller within about 5 m from front of the unit's remote-control sensor and within 30 degrees on both sides. With in 30 degrees With in 30 degrees About 5m SELECT CAUTIONS Do not use batteries of any kind not recommended for this product. Do not use new and old batteries together. The batteries could explode or leak, resulting in fires, physical injury, or stains. When loading batteries, observe their correct polarities as marked on the product. If loaded in the wrong direction, the batteries could explode or leak, resulting in fires, physical injury, or stains. TIPS 12 Do not drop or impact the remote controller. Do not splash the remote controller with water or put it on a wet object to avoid possible failures. Before leaving the remote controller out of use for an extended period of time, remove the batteries from it. If the remote controller begins to lack responsiveness, replace the batteries. Strong light such as direct sunlight impinging on the photoreceptor of the remote control can cause operational failure. Position this unit to avoid direct contact with such light.