Homelite UT10660 User Manual - Page 25

MAINTENANCE WARNING: Make sure the on/stop switch is in the STOP " " position and the chain has stopped before performing any maintenance on the saw. Failure to do so may result in serious personal injuries. RUN POSITION WARNING: Muffler surfaces are very hot during and after operation of the chain saw; keep all body parts away from the muffler. Serious burns may occur if contact is made with the muffler. Fig. 34 BAR MOUNTING NUTS WARNING: When servicing, use only identical Homelite replacement parts. Use of any other parts may create a hazard or cause product damage. WARNING: Aways wear eye protection with side shields marked to comply with ANSI Z87.1, along with hearing and head protection. Failure to do so could result in objects being thrown into your eyes and other possible serious injuries. GENERAL MAINTENANCE Avoid using solvents when cleaning plastic parts. Most plastics are susceptible to damage from various types of commercial solvents and may be damaged by their use. Use clean cloths to remove dirt, dust, lubricant, grease, etc. WARNING: Do not at any time let brake fluids, gasoline, petroleum-based products, penetrating oils, etc., come in contact with plastic parts. Chemicals can damage, weaken or destroy plastic which may result in serious personal injury. COMBINATION WRENCH Fig. 35 BAR MOUNTING NUTS SPROCKET CLUTCH COVER Fig. 36 LUBRICATION All of the bearings in this product are lubricated with a sufficient amount of high grade lubricant for the life of the unit under normal operating conditions. Therefore, no further lubrication is required. Page 25 - English