Homelite UT10660 User Manual - Page 27
Adjusting Pin, Clutch, Cover, Sprocket, Chain Tensioning, Pin Hole, Mounting, Chain, Tensioning,
View all Homelite UT10660 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 27 highlights
MAINTENANCE so that it is aligned with the position of the bar chain tensioning pin hole. n Replace the clutch cover and bar mounting nuts. n Finger-tighten the bar mounting nuts. The bar must be free to move for tension adjustment. n Remove all slack from the chain by turning the chain tensioning screw clockwise until the chain seats snugly against the bar with the drive links in the bar groove. n Lift the tip of the guide bar up to check for sag. n Hold the tip of the guide bar up and tighten the bar mounting nuts securely. The chain is correctly tensioned when there is no sag on the underside of the guide bar, the chain is snug, but it can be turned by hand without binding. Ensure that the chain brake is not set. NOTE: If chain is too tight, it will not rotate. Loosen the bar nuts slightly and turn the tension adjuster 1/4 turn counterclockwise. Lift the tip of the guide bar up and retighten the bar nuts securely. Ensure that the chain will rotate without binding. CLUTCH COVER ADJUSTING PIN CHAIN TENSIONING SCREW Fig. 40 GUIDE BAR Fig. 41 BAR MOUNTING NUTS CHAIN TENSIONING PIN HOLE CLUTCH COVER SPROCKET BAR MOUNTING NUTS Fig. 39 Page 27 - English Fig. 42