Hoover C1800 Manual
Hoover C1800 - Conquest Upright Vac 14 Manual
 |
UPC - 073502022467
View all Hoover C1800 manuals
Add to My Manuals
Save this manual to your list of manuals |
Hoover C1800 manual content summary:
- Hoover C1800 | Manual - Page 1
Owner's Manual Operating and Servicing Instructions www.hoover.com Please review this manual before operating your Hoover® appliance. This cleaner meets Occupational Safety and Health Act (OSHA-29 CFR 1910 Subpart S) requirements. ©2008 All rights reserved. #59156659 R0. 10/08 Manuel du Proprié - Hoover C1800 | Manual - Page 2
both sides of the dirt cup; lock 10. Latches: 11 10 Dirt receptacle of the cleaner. 10 9 9. Dirt Cup: 8. Cord Clamp And Cord Protector 7. Handle 4 Loop cord around hook for storage. 6. Cord Storage Hook: 8 bag. Place spring ring over hook to support the 5. Spring Hook: 5 4. Outer - Hoover C1800 | Manual - Page 3
or dropped into water, take it to a Hoover Factory Service Center or Authorized Hoover Commercial Warranty Service Distributor. • Use only as described in this manual. Use only manufacturer's recommended attachments. SAVE THESE INSTRUCTIONS! 3 CONSIGNES DE SÉCURITÉ IMPORTANTES Pendant l'utilisation - Hoover C1800 | Manual - Page 4
cleaner to protect it from overheating. When the thermal protector activates the cleaner will stop running. If this happens proceed as follows: 1. Turn cleaner bag inlet openings for any obstructions. Clear obstructions if present. 3. When cleaner is unplugged and motor or service person cord - Hoover C1800 | Manual - Page 5
from electrical outlet before attempting to service it in any manner. Do not operate cleaner without either cloth dirt bag or paper throw away bag. Power Cord To reduce twisting of the power cord, start at the cleaner handle end of the cord and coil before storing on storage hook. Heavy Object Clean - Hoover C1800 | Manual - Page 6
Paper Throw Away Bag A HOOVER® Type A paper throw away bag may be used with the cleaner in place of the cloth dirt bag. Remove cloth dirt bag from cleaner following directions previously given and remove bag closure clip from dirt bag. Reposition bag closure clip inside top of outer bag and attach - Hoover C1800 | Manual - Page 7
spring and place handle in upright position. Allow a few seconds for dirt to settle into cup. While supporting bottom of cup, release the two latches by pulling them outward as shown. Remove cup and empty it Reposition cup up into support at bottom of bag and snap latches into position. Le vide - Hoover C1800 | Manual - Page 8
. Tighten screws with screwdriver. Belts: What to Buy Use only genuine HOOVER belts with your cleaner. When purchasing a new Flat Belt, ask for HOOVER part No. 38528036. When purchasing a new V-Belt, ask for HOOVER part No. 38528013. 2.12 A Turn cleaner over. Place V-belt into groove of agitator - Hoover C1800 | Manual - Page 9
HOOVER agitator roll sleeves with your cleaner. For the Conquest 14, ask for HOOVER part No. 48416013. For the Conquest 18, ask for HOOVER part No. 48416017. If agitator does not rotate, the V-belt of agitator in opposite directions until one end plate comes off. In order to remove bearing and washer - Hoover C1800 | Manual - Page 10
10 PROBLEM Cleaner won't run Cleaner won't pick up or low suction Cleaner is hard to push 1. Bag/Dirt Cup full. 2. Agitator brushes worn. 3. Broken or worn belt. 4. Carpet height setting is incorrect. 5. Agitator not rotating. 6. Heavy object clean-out full of debris. 1. Carpet height setting is - Hoover C1800 | Manual - Page 11
del Propietario Instrucciones de Funcionamiento y Servicio www.hoover.com Repase por favor este manual antes de funcionar su aplicación de Hoover®. Esta aspiradora cumple con los requisitos de la Ley de seguridad y salud ocupacional (Occupational Safety and Health Act, OSHA; Título 29 Sección 1910 - Hoover C1800 | Manual - Page 12
de modelo y serie en los espacios provistos. Modelo MFG Code Consejo: Adjunte su recibo de compra a este manual del usuario. Para obtener el servicio de garantía de compra de su producto HOOVER, es posible que se requiera la verificación de la fecha de compra. MFG Code Descripción de la - Hoover C1800 | Manual - Page 13
Service (Mantenimiento) de Hoover Inc., en Internet en www.hoover.com No envíe su aspiradora a Hoover Vac las partes del use este aparato con un cordón o enchufe dañado. Hoover o Distribuidor de servicio de garantía comercial autorizado de Hoover. • Use el producto sólo como se describe en este manual - Hoover C1800 | Manual - Page 14
cord motor Conquest 14, solicite la pieza n° 48416013 de HOOVER. Para el Conquest 18, solicite la pieza n° 48416017 de HOOVER. Si el agitador no rota, la correa en V no está colocada correctamente en la acanaladura de la polea guía. Si esto sucede, proceda de la siguiente manera: 1. Disconnect cleaner - Hoover C1800 | Manual - Page 15
motor y la polea guía. A Con la inscripción hacia la parte exterior de la correa nueva, deslice la correa B alrededor de la polea guía y la polea del motor papel. Cordón de alimentación Para reducir la posibilidad de que se tuerza el cordón de alimentación, comience por el extremo del cordón del - Hoover C1800 | Manual - Page 16
Es posible usar una bolsa desechable de papel tipo A de HOOVER® con la aspiradora en lugar de una bolsa de tela para parte inferior del depósito, suelte las dos trabas tirando hacia afuera, como se muestra. Retire el depósito y vacíelo. Reposition cup up into support at bottom of bag and snap latches
-
1 -
2 -
3 -
4 -
5 -
6 -
7 -
8
-
9
-
10
-
11
-
12
-
13
-
14
-
15
-
16
 |
 |
www.hoover.ca
Manuel du Propriétaire
Notice d’utilisation et d’entretien
©
2008
Tous droits réservés
. #59156659 R0. 10/08
Veuillez lire attentivement ces instructions avant d’utiliser votre appareil Hoover
MD
.
Cet appareil est conforme aux exigences de la Loi sur la santé et la sécurité au travail
(29 CFR 1910, sous paragraphe S).
Please review this manual before operating your Hoover® appliance.
www.hoover.com
Owner’s Manual
Operating and Servicing Instructions
©2008 All rights reserved. #59156659 R0. 10/08
This cleaner meets Occupational Safety and Health Act (OSHA-29 CFR 1910 Subpart S) requirements.