Hoover F7411900 Product Manual - Page 15
Warning - brushes not turning
UPC - 073502029244
View all Hoover F7411900 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 15 highlights
Cleaning carpeted stairs Read "Before You Begin Cleaning" instructions on page 10. Attach hose and solution tube as instructed in Figs. 4.1 and 4.2. Place handle in upright position. Agitator brushes will not rotate while handle is in upright position. Fill clean water tank according to instructions for Figs. 2.9 to 2.11. Fill detergent container with HOOVER® detergent according to instructions for Fig. 2.11. Attach tool to end of hose. Hose length may require that machine be placed at the top of the stairs to clean upper half of stairway and at bottom of stairs to clean lower half. ! WARNING ! To prevent machine from falling, use extra caution when cleaning on stairs. Do not place cleaner on stairs. Do not point tools toward people or pets. Dry hands and plug cleaner into a properly grounded outlet. Set Rinse Setting switch to WASH. Turn cleaner ON. 4.9 Pre-spray the carpeted stair by holding the tool (A) or (B) about one inch above the carpet and push it forward while pressing the trigger (equals one wet stroke). 4.9 4.10 A B Position tool against the riser and slightly press it into carpet pile. Press the trigger and pull the tool slowly over the carpet (second wet stroke). Release trigger at end of stroke. 4.10 Lift tool, and position it against riser. Pull tool slowly over carpet without pressing trigger (dry stroke). Overlap strokes by 1/2 inch to help prevent streaking. It is best to alternate wet and dry strokes as described above. End with more dry strokes to aid in faster drying of carpet. To avoid saturating carpet, do not use more than 4 wet strokes over any one area. Always end with dry strokes. If additional cleaning is necessary, wait until the carpet is completely dry before using the tool again. Empty Dirty Water Tank when the motor sound becomes higher pitched and there is a loss in suction (see "Automatic Shut-Off", Fig. 2.17). When finished cleaning, follow "After Cleaning" instructions on page 12 and "After Using Tool" instructions on page 14. 15 Actual model may vary from images shown.