Hoover U2440900W Manual - Page 10
hood A. Lift hood off.
View all Hoover U2440900W manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 10 highlights
3-12 3-13 3-14 B Remove 2 screws from bottom plate. Removing hood Lower cleaner base so it is flat on the floor. Remove 2 screws located at back of hood (A). Lift hood off. Remove 2 screws on agitator cover (B). 3-15 3-16 3-17 D Lift agitator cover off. C Grasp agitator (C) and pull up to remove from agitator cavity. E Slide belt (D) off agitator. Remove belt from motor shaft (E). Discard used belt. 3-18 3-19 G F 3-20 Position new belt on agitator brush roll With lettering on outside of belt, insert agitator brush roll through belt and position belt in groove (F) on agitator brush roll. Installing agitator brush roll Grasp agitator brush roll firmly and fit it into position by first sliding end opposite the belt into the rectangular slot (G) on side of cleaner. Pull other side of agitator brush roll into place. Reposition agitator cover over agitator. Replace 2 screws. 10