Hoover U2440900W Manual - Page 9
Belt replacement
View all Hoover U2440900W manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 9 highlights
3-7 3-8 3-9 With pleated filter facing outward, align tabs at bottom of filter frame assembly with slots in bottom of dirt cup. Snap filter frame into place. Place bottom of dirt cup into cleaner body first. Pivot cup into cleaner body. Press on dirt cup release button while firmly pressing on dirt cup. Release button in order for it to return to proper position and lock the dirt cup into place. Do not operate cleaner without dirt cup or filters in place. 3-10 A Final filter Disconnect cleaner from electrical outlet. Do not operate cleaner without dirt cup or filters in place. Remove dirt cup as described in Fig. 3-2. Remove black foam filter (A) from underneath tabs. Rinse foam filter under cold water. Allow filter to air dry for 24 hours before replacing filter into cleaner. Reposition filter by inserting under tabs on back of housing. What to buy When purchasing a new final filter, ask for HOOVER filter package No. 40110-013 (filter part No. 1BEB124710000). Belt replacement The belt is located under the cleaner hood and should be checked from time to time to be sure it is in good condition. 3-11 When to replace Disconnect cleaner from electrical outlet. WARNING: Agitator brush roll can start suddenly. Unplug cleaner before replacing belt. To check the belt, remove hood as shown in Items 3-11 through 3-13. Replace belt if it is stretched, cut or broken. What to buy To assure effective operation, use only genuine HOOVER belts with your cleaner. When purchasing a new belt, ask for HOOVER belt package No. 40201-280 (belt part No. 2BEB120800300). Replacing flat belt Disconnect cleaner from electrical outlet. Put agitator brush roll in the HARD FLOOR position. WARNING: Agitator brush roll can start suddenly. Unplug cleaner before replacing belt. Lay cleaner flat with bottom of cleaner facing up as shown. Continued § 9