Hoover U8351900 Manual - Page 11

Final filter A B Headlight Headlight replacement What to buy This cleaner uses a T3 1/4 wedge base bulb, HOOVER part no. 27313107. Remove lens 35 Disconnect cleaner from electri- cal outlet. Do not use cleaner without dirt cup or filters in place. The final filter assists in returning clean air to the room. Remove dirt cup (Fig. 29). Press on handle release pedal and lower the nozzle so it is flat. Using a Phillips screwdriver, remove the four screws as shown and lift off headlight lens (A). Lift out filter (B) and replace. Replace lens and screws. Should you want to replace this filter, ask for HOOVER part no. 38769032. Replace lens Disconnect cleaner from electrical outlet. 36 Press on handle release pedal and lower the nozzle so it is flat. Using a Phillips screwdriver, remove the four screws as shown and lift off lens. Agitator brush roll Check agitator brush roll When agitator brush roll brushes are worn, the agitator brush roll should be replaced. To check condition of brushes, turn cleaner OFF and disconnect from electrical outlet. 37 Pull old bulb straight out of socket. Push new bulb straight into socket until locked in place. Do not twist bulb. Excessive force is not required. 12 38 Reposition lens and secure with the four screws. 39 Move edge of a card across bot- tom plate while turning agitator brush roll. To maintain cleaning effectiveness, replace agitator brush roll if brushes do not touch card.