Hoover U9125-900 Manual - Page 16

Troubleshooting - manual

Page 16 highlights

Troubleshooting Use the chart below as a guide to the indicator lights on the control panel. What's the problem? What does it mean? Agitator stall light (C) ON; See Manual light (A) ON; Power light blinking. Cleaner will not run. What to do Obstruction in agitator. A  Turn the cleaner OFF and unplug. Turn cleaner over. Check for obstruction and remove. What's the problem? What does it mean? Suction motor light (D) ON; See Manual light (A) ON; Suction motor has overheated. Power light blinking. Cleaner will not run. What to do  Check dirt cup. Empty if full.  Refer to "Clearing blockages" on pages  Check final filter. Clean if dirty.  Turn the cleaner OFF and unplug. 12 and 13. Clear any blockages. Wait 15 minutes; plug cleaner back in and turn ON. What's the problem? What does it mean? Height adjustment light (LOW, MED or HIGH) Nozzle is unable to move to continuously blinking. selected setting. (NOTE: Light will blink, then stop as it transi- tions between carpet heights.) What to do   The cleaner can still be Turn cleaner OFF, then used. ON. If light continues to blink, take cleaner to a HOOVER Sales & Service Center for service. What's the problem? What does it mean? Filter light (B) ON; See Manual light (A) ON. HEPA filter not turning or turning slower than normal. Filter not rotating; jam in filter drive. What to do C  Place cleaner in the upright position with hose end connected to the wand. Turn cleaner OFF, empty dirt cup and clean pre-filter screen. Turn back ON. If filter now turns, allow it to run for one minute. After one minute, turn cleaner OFF and empty dirt cup. Continue cleaning.  If the filter is still not turning, take to a HOOVER Sales & Service Center for service. What's the problem? What does it mean? Power light blinking; See Manual light (A) ON. Cleaner will not run. Internal system problem. What to do  Turn the cleaner OFF, then back ON. If the lights remain the same, service is needed. Take to a HOOVER Sales & Service Center. What's the problem? What does it mean? Power light blinking; See Manual light (A) blinking. Cleaner will not run. Internal system problem. What to do  Turn the cleaner OFF, then back ON. If the lights remain the same, service is needed. Take to a HOOVER Sales & Service Center. 16 B D

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
  • 40
  • 41
  • 42
  • 43
  • 44
  • 45
  • 46
  • 47
  • 48

16
A
B
C
D
Troubleshooting
Use the chart below as a guide to the indicator lights on the control panel.
Agitator stall
light (C)
ON
;
See Manual
light (A)
ON
;
Obstruction in agitator.
Power
light
blinking
. Cleaner will not run.
Turn the cleaner OFF and unplug. Turn cleaner over. Check for obstruction and remove.
Suction motor
light (D)
ON
;
See Manual
light (A)
ON
;
Suction motor has overheated.
Power
light
blinking
. Cleaner will not run.
Check dirt cup. Empty if full.
Check final filter. Clean if dirty.
Refer to “Clearing blockages” on pages
Turn the cleaner OFF and unplug.
12 and 13. Clear any blockages.
Wait 15 minutes; plug cleaner back in
and turn ON.
Height adjustment
light (LOW, MED or HIGH)
Nozzle is unable to move to
continuously blinking
.
selected setting. (NOTE: Light
will
blink
, then stop as it transi-
tions between carpet heights.)
The cleaner can still be used.
Turn cleaner OFF, then ON. If light continues to blink, take cleaner to a HOOVER Sales
& Service Center for service.
Filter
light (B)
ON
;
See Manual
light (A)
ON
. HEPA
Filter not rotating; jam in filter
filter not turning or turning slower than normal.
drive.
Place cleaner in the upright position with hose end connected to the wand. Turn cleaner
OFF, empty dirt cup and
clean pre-filter screen
. Turn back ON. If filter now turns, allow it
to run for one minute. After one minute, turn cleaner OFF and empty dirt cup. Continue
cleaning.
If the filter is still not turning, take to a HOOVER Sales & Service Center for service.
Power
light
blinking
;
See Manual
light (A)
ON
.
Internal system problem.
Cleaner will not run.
Turn the cleaner OFF, then back ON. If the lights remain the same, service is needed.
Take to a HOOVER Sales & Service Center.
Power
light
blinking
;
See Manual
light (A)
blinking
.
Internal system problem.
Cleaner will not run.
Turn the cleaner OFF, then back ON. If the lights remain the same, service is needed.
Take to a HOOVER Sales & Service Center.
What to do
What’s the problem?
What does it mean?
What to do
What’s the problem?
What does it mean?
What to do
What’s the problem?
What does it mean?
What to do
What’s the problem?
What does it mean?
What to do
What’s the problem?
What does it mean?
What to do
What’s the problem?
What does it mean?