Hoover UH72400 Product Manual - Page 26
Air-powered Hand Tool - belt
View all Hoover UH72400 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 26 highlights
BELT ! CAUTION ! To reduce the risk of injury from moving parts - Unplug before servicing. 4.17 4.18 The belt is located under the bottom plate of the vacuum and should be checked from time to time to be sure it is in good condition. When To Replace Replace belt if it is damaged, cut or broken. To check the damaged belt, refer to Fig. 4.17 - 4.18. How To Replace Place handle in the operating position and turn the cleaner over so the bottom side is up. 4.17 Remove the 4 screws as shown with a Phillips screwdriver. 4.19 A 4.20 4.18 Lift off bottom plate (A). 4.19 Remove agitator brushroll and used belt. Discard used belt. 4.20 With the lettering on the outside of the belt and positioned as shown place belt in belt guide on the agitator. Should the agitator become dislodged while replacing the belt, reposition it as shown. Grasp agitator firmly and fit it into position by first sliding end opposite of belt into the rectangular slot on side of cleaner. Pull other side of agitator into place. Turn the agitator making sure the belt is not pinched between agitator and agitator shield. 4.21 Belt: What to Buy Use only genuine HOOVER® belts with your vacuum. When purchasing a new belt, ask for Belt HOOVER® part No. 562535001. 4.21 Place the bottom plate aligning the screw holes and install the 4 screws as shown. LUBRICATION: The motor and brushroll are equipped with bearings which contain sufficient lubrication for their lifetime. The addition of lubricant could cause damage. Do not add lubricant to motor or brushroll. AIR-POWERED HAND TOOL*: How to Clean 4.15 A 4.16 B (Tool varies per model) ! CAUTION ! To reduce the risk of injury from moving parts Unplug before servicing. 4.15 Turn tool so bottom faces up. Rotate the latches (A) on either side of tool. 4.16 Remove bottom plate (B). 4.17 Remove any debris and/ or hair from brushroll. Replace bottom plate by aligning tabs along front edge of tool. Rotate latches back into locked position. *Available on select models only 4.17 13