Husqvarna 325HE3 Operation Manual - Page 10
Assembly
View all Husqvarna 325HE3 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 10 highlights
ASSEMBLY Fitting the hand guard and loop handle (325HE3) Adjusting the harness (325HE4) 1 Slide the spacer into the slot in the loop handle. 2 Fit the nut and screw. Do not overtighten. You should always use the harness with the machine to give maximum control over the machine and reduce the risk of fatigue in your arms and back. 1 Put on the harness. 2 Hook the machine onto the harness support hook. 3 Adjust the length of the harness so that the support hook is roughly level with your right hip. 3 Now make a final adjustment to give yourself a comfortable working position. Tighten the screw. CAUTION! The loop handle and hand guard must not be fitted behind the arrow marked on the shaft. Fitting the impact guard (325HE4) Fitting the handle Fit the guard using the three screws and washers. Fit the two short screws in hole A. Tighten the screws to a torque of 4 Nm. After the machine has been in use for around 20 hours, re-tighten the screws to 4 Nm. Fit the handle using two screws. 10 - English