Husqvarna 325HE3 Operation Manual - Page 9
General Safety Precautions
View all Husqvarna 325HE3 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 9 highlights
GENERAL SAFETY PRECAUTIONS Regularly check that the muffler is securely attached to the machine. Blades If the muffler on your machine is fitted with a spark arrestor mesh this must be cleaned regularly. A blocked mesh will cause the engine to overheat and may lead to serious damage. To ensure good cutting results it is important that the contact pressure between the blades is correct. The contact pressure is adjusted by turning the screws on the underside of the bar clockwise as far as they will go. Then turn the screws anticlockwise a 1/4 turn. Lock the screws using the locking nut on the top of the bar. Check that the screws are loose enough to allow the washers under the screw heads to slide sideways. WARNING! Mufflers fitted with catalytic ! converters get very hot during use and remain so for some time after stopping. This also applies at idle speed. Contact can result in burns to the skin. Remember the risk of fire! WARNING! The inside of the muffler ! contain chemicals that may be carcinogenic. Avoid contact with these elements in the event of a damaged muffler. WARNING! Bear in mind that: ! The exhaust fumes from the engine are hot and may contain sparks which can start a fire. Never start the machine indoors or near combustible material! When the blades are correctly adjusted the play between the blades should be 0,2-0,4 mm, measured at the screws. The edges of the blades are too hard to be filed. Dull blades should be sharpened using a grinder. Check that the blades are undamaged and show no signs of cracking or other damage. Gear The gear housing gets hot when the machine has been in use. To avoid burning yourself do not touch the gear housing. English - 9