Husqvarna 520iHT4 Owner Manual - Page 13
To adjust the angle of the product
View all Husqvarna 520iHT4 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 13 highlights
To adjust the angle of the product The cutting attachment can be adjusted in 8 different positions. 1. Remove the battery from the product. 2. Pull down the position adjustment handle. 3. Tighten the knob. 3. Tilt the cutting attachment with the handle to the applicable position. To use the SavE function This product has a power saving function, SavE. The SavE function decreases the speed of the cutting equipment and gives the longest operation time from the battery. Note: The SavE function does not decrease the cutting power of the product. 1. Push the SavE button on the keypad to start the function. The green LED comes on. 2. Push the SavE button again to stop the function. The green LED goes out. 4. Release the position adjustment handle to lock the cutting attachment. To adjust the length of the shaft 1. Release the knob. 2. Pull out the shaft to the applicable length. Automatic shutdown function The product has an automatic shutdown function that stops the product if it is not used. The green LED for start/stop indication goes off and the product stops after 45 seconds. To set the product in transport position WARNING: Do not start the product when the product is in transport position. 1. Remove the battery from the product. 2. Install the transport guard on the cutting attachment. 3. Fold the cutting attachment 180° to make the cutting attachment parallel to the shaft. 1266 - 002 - 19.08.2020 13