Husqvarna DT22 Owners Manual - Page 21
Drive Belt, Check that guide and tensiOning equipment
View all Husqvarna DT22 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 21 highlights
MAINTENANCE Drive Belt 1. When checking the drive belt, allow the engine to cool. 2. Remove the spark plug cable. 3. Remove the belt guard (see illustration) on the left side of the machine. 4. Check that the belt is running in the proper track; the pulleys should guide the belt in a straight line. 5. Check that the belt and pulleys are not oily. If they are, first try to clean them with spirits. If they are heavily coated, take the machine to an authorized service workshop to fix the oil leakage and replace the belt. 8011-027 6. Check the belt for cracks, heat damage or worn edges. 7. Check that guide and tensioning equipment for the belt is not loose and is properly set. 8. If the belt needs to be replaced - loosen the belt guides. Remove belt cover 9. Remove the old belt. 10. Check for wear on the pulleys and replace as necessary. 11. Check the engine pulley alignment to the rotor pulley and adjust as necessary. The belt should run straight. 12. Fit a new belt by first pulling it over the lower pulley and then the engine pulley. Check that the tensioning pulley and belt guides end up outside the belt loop. 13. Tighten belt guides and refit the belt guard. Check drive belt DT06 DT07-1 8060-018 21