Husqvarna DT22 Owners Manual - Page 24
Delta Blades, Spring tines, Wear/Replacing
View all Husqvarna DT22 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 24 highlights
MAINTENANCE Delta Blades Wear/Replacing Over time and due to wear, the blades will diminish in length. Once the blades have worn down by about ¾" (19 mm), the overall length of the blade at the longest point of the blade will be about 2½" (64 mm), and it will be necessary to replace the blades. It is possible to replace delta blades without removing the rotor shaft. Remove the delta blade by removing the two screws with nuts holding the blade in place. Turn the new blade until it is properly aligned; see illustration. Screws Delta Blade Washers Nuts Spring tines Wear/Replacing Over time and due to wear, the tines will diminish in length. When the tines can no longer be adjusted to comb ¼" (6 mm) into the soil, the tines must be replaced. Spring tines can be replaced without removing the rotor shaft by using a ½" socket wrench. Remove the screw and replace the spring tine using the wrench. Spring Tine NOTE: Do not use spring tines with bagger attachment. 24 Screw