Husqvarna FT900 Owners Manual - Page 13
Service And Adjustments - engine
View all Husqvarna FT900 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 13 highlights
SERVICE AND ADJUSTMENTS CAUTION: Disconnect spark plug wire from spark plug and place wire where it cannot come into contact with plug. TILLER TO ADJUST HANDLE HEIGHT (See Fig. 15) Factory assembly has provided lowest handle height. Select handle height best suited for your tilling conditions. Handle height will be different when tiller digs into soil. • If a higher handle height is desired, loosen the four nuts securing handle panel to engine brackets. • Slide handle panel to desired location. • Tighten the four nuts securely. ENGINE BRACKETS HANDLE PANEL NUTS (ALSO 2 ON LEFT SIDE OF TILLER) MID-WIDTH TILLING - 24 INCH PATH (See Fig. 17) • Assemble holes "A" in tine hubs to holes "C" in tine shaft. A C C A tine_5 Fig. 17 NARROW TILLING/CULTIVATING - 12-3/4 INCH PATH (See Fig. 18) • Remove outer tines. tine_6 Fig. 15 TINE ARRANGEMENT Your outer tines can be assembled in several different ways to suit your tilling or cultivating needs. CAUTION: Tines are sharp. Wear gloves or other protection when handling tines. NORMAL TILLING - 26 INCH PATH (See Fig. 16) • Assemble holes "A" in tine hubs to holes "B" in tine shaft. CLEVIS PIN OUTER TINE A A INNER TINES ONLY Fig. 18 NOTE: When reassembling outer tines, be sure right tine assembly (marked "R") and left tine assembly (marked "L") are mounted to correct side of tine shaft. B tine_4 HAIRPIN CLIP B INNER TINE Fig. 16 13