Husqvarna FT900 Owners Manual - Page 5
Install Depth Stake Assembly, See Fig. 3, Handle Height, Tilling Width, Tine Operation - front tine tiller
View all Husqvarna FT900 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 5 highlights
ASSEMBLY UNPACK CARTON & INSTALL HANDLE (See Fig. 2) CAUTION: Be careful of exposed staples when handling or disposing of cartoning material. IMPORTANT: WHEN UNPACKING AND ASSEMBLING TILLER, BE CAREFUL NOT TO STRETCH OR KINK CABLE(S). • Cut cable ties securing handles. • Slowly lift handle assembly up, route cable(s) as shown and align handle holes with handle panel hole and slot. • Loosely assemble hardware as shown. Be sure the shorter (1" long) hex bolt is assembled in lower hole of handle. Repeat for opposite side. Tighten all hardware securely. • Cut cable ties securing tiller to skid and remove tiller from skid. • Remove screws securing depth stake to skid and discard the screws. INSTALL DEPTH STAKE ASSEMBLY (See Fig. 3) • Loosen nut "A". • Insert stake support between engine bracket halves with stake spring down. • Bolt stake support to engine brackets with bolts, lock washers and nuts. Tighten securely. Tighten nut "A". • Depth stake must move freely. If it does not, loosen support bolt. depth_stake_4 ENGINE BRACKET HALVES NUT "A" DEPTH STAKE SUPPORT STAKE SPRING HANDLE PANEL CABLE(S) TILLER HANDLES LOCK NUT WASHER TILLER HANDLE FLAT WASHER &4 (ANDLEª0ANEL? HEX BOLT 5/16-18X1-1/4" HEX BOLT 5/16-18X1" 02051 HANDLE PANEL BOLTS DEPTH STAKE HEX BOLTS, LOCK WASHERS, AND HEX NUTS SUPPORT BOLT Fig. 3 HANDLE HEIGHT • Handle height may be adjusted to better suit operator. (See "HANDLE HEIGHT" in the Service and Adjustments section of this manual). TILLING WIDTH • Tilling width may be adjusted to better handle your tilling conditions (See "TINE ARRANGEMENT" in the Service and Adjustments section of this manual). TINE OPERATION • Check tine operation before first use. (See "TINE OPERATION CHECK" in the Service and Adjustments section of this manual). Fig. 2 5