Husqvarna MZ 52LE Limited Edition Operation Manual - Page 23
Safety System, Cutting Blades, Park Brake, IMPORTANT INFORMATION, CAUTION, WARNING
View all Husqvarna MZ 52LE Limited Edition manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 23 highlights
MAINTENANCE Safety System The machine is equipped with a safety system that prevents starting or driving under the following conditions. The engine can only be started when: • the mower deck is disengaged. • the steering controls are in the outer, locked neutral position. • the park brake is on. For the best mowing effect, it is important that the blades are well sharpened and not damaged. Replace blades that have been bent or cracked when hitting obstacles. Let the service workshop decide whether a blade with large nicks can be repaired/ground or must be replaced. Balance the blades after sharpening. Check the blade mounts. Blade Replacement 1. Remove blade bolt by turning it counter clockwise. 2. Install new or re-sharpened blade with stamped GRASS SIDE facing towards ground/grass (down) or THIS SIDE UP facing deck and cutter housing. 3. Install and tighten blade bolt securely. 4. Torque blade bolt to 45-55 lb-pie (122 Nm). IMPORTANT INFORMATION The special blade bolt is heat treated. Replace it with a Husqvarna bolt if required. Do not a use lower grade hardware than specified. Make daily inspections to ensure that the safety system works by attempting to start the engine when one of the conditions is not met. Change the conditions and try again. If the machine starts when one of these conditions is not met, turn the machine off and repair the safety system before using the machine again. Make sure the engine stops when the park brake is not engaged and the operator leaves the seated position. Check that the engine stops if the mower blades are engaged and the driver temporarily moves off the driver's seat. Park Brake Visually check that no damage is found on the lever, links, or switch belonging to the park brake. Perform a standstill test and check that there is sufficient braking. For park brake adjustments, contact the Husqvarna service workshop. WARNING! Faulty adjustment will result in reduced braking and can cause an accident. Tire Pressures All tires must be at 15 psi / 103 kPa / 1 bar. IMPORTANT INFORMATION To be able to drive, the driver must sit in the seat and release the park brake before the steering controls can be moved into the neutral position, otherwise the engine will stop. Cutting Blades CAUTION! Blades are sharp. Protect your hands with gloves and/or wrap blades with a heavy cloth when handling. The sharpening of blades must be carried out by an authorized service workshop. IMPORTANT INFORMATION DO NOT add a tire liner or foam fill material to the tires. Excessive loads created by foam filled tires will cause premature failures. Only use tires specified by Husqvarna. 23