Husqvarna R 322T AWD Owners Manual

Husqvarna R 322T AWD Manual

Get Husqvarna R 322T AWD PDF manuals and user guides View all Husqvarna R 322T AWD manuals
Add to My Manuals
Save this manual to your list of manuals

Husqvarna R 322T AWD manual content summary:

  • Husqvarna R 322T AWD | Owners Manual - Page 1
    Operator′s manual Rider 220T Rider 322T AWD Please read the operator's manual carefully and make sure you understand the instructions before using the machine. English
  • Husqvarna R 322T AWD | Owners Manual - Page 2
    4 Use 4 Good service 4 KEY TO SYMBOLS Symbols 8 WHAT IS WHAT? What is what on the ride-on mower 10 SAFETY INSTRUCTIONS Safety instructions 11 steering wires 22 Adjusting the parking brake Rider 220T 23 Adjusting the parking brake Rider 322T AWD 23 Checking and adjusting of throttle wire 23
  • Husqvarna R 322T AWD | Owners Manual - Page 3
    of this journal on the second-hand value of the machine. Range of applications for BioClip. Complete proof of sale etc. Pre-delivery service carried out. No outstanding problems. Certified: Date, mileage, stamp, signature After the first 8 hours 1 Change engine oil 2 Change the oil in the gearbox
  • Husqvarna R 322T AWD | Owners Manual - Page 4
    By following its instructions (on operation, service, maintenance, etc.) you will significantly extend the life of the machine and even its second-hand value. When you sell your Rider, make sure you pass on the operator's manual to the new owner. The last chapter in the operator's manual consists of
  • Husqvarna R 322T AWD | Owners Manual - Page 5
    RULES FOR USA S• afe operation practices for ride-on mowers These instructions are for your safety. Read them carefully. IMPORTANT! This cutting machine is capable of amputating hands and feet and throwing objects. Failure to observe the following safety instructions could result in serious injury
  • Husqvarna R 322T AWD | Owners Manual - Page 6
    parts, when necessary. 9. Mower blades are sharp and can cut. Wrap the blade(s) or wear gloves and use extra caution when servicing them. 10. Check brake operation frequently. Adjust and service your vehicle before filling 7.Remove gas-powered equipment from the truck or trailer and refuel it on the
  • Husqvarna R 322T AWD | Owners Manual - Page 7
    by the manufacturer even for other special tasks for which instructions are delivered with the accessory. Use in any other way is considered as contrary to the intended use. Compliance with and strict adherence to the conditions of operation, service and repair as specified by the manufacturer also
  • Husqvarna R 322T AWD | Owners Manual - Page 8
    result in serious or fatal injury to the operator or others. Clutch out Warning: rotating parts. Keep hands and feet clear. Please read the operator's manual carefully and make sure you understand the instructions before using the machine. Always wear: • Approved hearing protection Rotary blades
  • Husqvarna R 322T AWD | Owners Manual - Page 9
    or maintenance Check the engine's oil level Check transmission oil level Lift up the cutting unit Apply the parking brake. If the engine is cold, use the choke Release the parking brake before driving The following labels are on the machine English - 9
  • Husqvarna R 322T AWD | Owners Manual - Page 10
    14 15 16 What is what on the ride-on mower 1 Speed limiter for driving forward 2 Speed limiter for reversing 3 Lifting lever for the cutting unit 4 Cutting height adjustment lever 5 Ignition lock 6 Throttle trigger 7 Choke control 8 Counter: 322T AWD 9 Cover lock 10 Parking brake 11 Lock button
  • Husqvarna R 322T AWD | Owners Manual - Page 11
    Rider. • Contact your insurance company. • You should have fully comprehensive insurance including: third party, fire, damage, theft and liability General use • Read all the instructions in this operator's manual . • Keep an eye on the traffic when working close to a road or when crossing it. •
  • Husqvarna R 322T AWD | Owners Manual - Page 12
    does happen. Ask your dealer for help in choosing the right equipment. • Use hearing protection to minimise the risk of hearing impairment. • Never wear loose fitting clothes that can catch in moving parts. • Never use the machine when barefoot. Always wear protective shoes or protective boots
  • Husqvarna R 322T AWD | Owners Manual - Page 13
    not modify safety equipment. Check regularly to be sure it works properly. The machine must not be driven if protective plates, protective covers, safety switches or other protective devices are not fitted or are defective. • Observe the risk of injury caused by moving or hot parts if the engine is
  • Husqvarna R 322T AWD | Owners Manual - Page 14
    use the machine indoors or in spaces lacking proper ventilation. Exhaust fumes contain carbon monoxide, an odourless, poisonous and highly dangerous gas. Engage the parking brake and tie the tension belts around stable parts the equipment originally that the parking brake works. Adjust and maintain
  • Husqvarna R 322T AWD | Owners Manual - Page 15
    pleasure for many years. This operator's manual describes Rider 220T and Rider 322T AWD. Speed limiter The speed of the machine is steplessly regulated with two pedals. Pedal (1) is used to drive forwards, and pedal (2) to drive backwards. 1 2 The machine 322T AWD are equipped with all wheel drive
  • Husqvarna R 322T AWD | Owners Manual - Page 16
    jointed attachment on the front edge and can be tipped forward. The lever can also be used to to the required position. Lights: 322T AWD The lights are switched on and off using the power switch on the control panel. instructions). IMPORTANT! Do not use the fuel tank as a support area.
  • Husqvarna R 322T AWD | Owners Manual - Page 17
    axle is disengaged when one of the controls is pulled out. Pull the controls to the end positions, do not use an intermediate position. Clutch control Rider 322T AWD Rider 322T AWD have one control for the front axle and one control for the rear axle. IMPORTANT! Always drive the machine with both
  • Husqvarna R 322T AWD | Owners Manual - Page 18
    Driving Before starting • Read the safety instructions and information concerning the placement of controls start position. STOP START Start the engine 1 Make sure that the clutch control is depressed. Rider 322T AWD have one control for the front axle and one control for the rear axle. 2 Lift
  • Husqvarna R 322T AWD | Owners Manual - Page 19
    recharged. When jump leads are used for emergency starting, follow the procedure below: IMPORTANT INFORMATION Your Rider is equipped with a 12-volt system with from both batteries. IMPORTANT INFORMATION The life span of the drive belts is increased significantly if the engine runs at a low speed
  • Husqvarna R 322T AWD | Owners Manual - Page 20
    the blades rotate rapidly) and low speed (the Rider moves slowly). If the grass is not too is used. The cutting unit should then be put in the service position. • When the BioClip function is used, minute to obtain normal working temperature before stopping it if it has been working hard. Avoid idling
  • Husqvarna R 322T AWD | Owners Manual - Page 21
    in the tyres. Lubricate the belt adjuster 1) Lubricate joints and shafts1) Adjust the brake Check the V-belts Check the cooling fins on service workshop. 7)Only 322T AWD first change after 8 hours X = Described in this operator's manual O = Not described in this operator's manual WARNING! No service
  • Husqvarna R 322T AWD | Owners Manual - Page 22
    the fender. Oily dirt can be removed using a cold degreasing agent. Spray on a you start the engine and run the mower for a short period after cleaning, problems. Cleaning additives generally aggravate the damage. Removing of the machine hoods Engine cover The engine becomes accessible for service
  • Husqvarna R 322T AWD | Owners Manual - Page 23
    much, without using unnecessary force. Adjusting the parking brake Rider 322T AWD Check that the throttle. If doubts arise, contact your service representative. If adjustment is necessary, adjust throttle position. 2 Check that the throttle wire is attached to the correct hole in the lower lever,
  • Husqvarna R 322T AWD | Owners Manual - Page 24
    If doubts arise, contact your service representative. If it is necessary to If the engine seems to lack power or does not run smoothly this Check that the throttle wire is attached to the upper lever, see diagram. 2 Move the hose clips away from the filter. Use a pair of flat pliers. 3 Pull off the fi
  • Husqvarna R 322T AWD | Owners Manual - Page 25
    Tighten the spark plug so that the washer is compressed. A used spark plug should be turned 1/8 of a turn from the head. Check the safety system The machine is equipped with a safety system that prevents starting or daily to ensure that the safety system works by attempting to start the engine when one
  • Husqvarna R 322T AWD | Owners Manual - Page 26
    322T AWD For information about the bulb type, see Technical Data. 1 Unscrew the two screws holding the cover on the power place in the locking bracket Do not use any other type of fuse when replacing. xed before the machine can be put into operation again. Checking the tyre pressure The tyre
  • Husqvarna R 322T AWD | Owners Manual - Page 27
    belt in the belt holder. Open the engine cover. Check that the cooling intake is free from leaves, grass and dirt. A blocked cooling intake will interfere with the cooling of the engine, which can damage the engine. 5 Push the deck in and put the front guide plugs in the grooves on the equipment
  • Husqvarna R 322T AWD | Owners Manual - Page 28
    belt may break and cause personal injury. 1 Carry out points 1-6 to put the cutting unit in the service position, see Service . Pressure is adjusted using a screw and spring on each side of the Rider. 1 Check the air between the frame and scales so that the support wheels do not bear any weight. 5
  • Husqvarna R 322T AWD | Owners Manual - Page 29
    edge 2-4 mm (1/ 8") higher than the front edge. Replacing the cutting unit belts WARNING! Wear gloves to protect your ! hands when working with the blades. There is a risk of crush injuries when working with the belt. On these cutting units with collision-proof blades, the blades are driven by
  • Husqvarna R 322T AWD | Owners Manual - Page 30
    unit cover. 4 Disengage the spring for the drive belt tensioning wheel. 8 Loosen the spring that tensions the V-belt and pry off the belt. 5 Loosen on the cutting height stay and place in the holder. Assemble the parts in the reverse order. Service position for the cutting unit The cutting head
  • Husqvarna R 322T AWD | Owners Manual - Page 31
    located under the unit with three screws. 1 Put the unit in the service position, see Placing in the service position. 2 Remove the three screws holding the BioClip plug, and remove the plug. 3 Tension the belt with the belt adjuster. 4 Fit the front cover. Checking the blades To achieve the best
  • Husqvarna R 322T AWD | Owners Manual - Page 32
    the Rider oil classes are recommended: • API Service Class: SF, SG, SH and Checking the engine's oil level for filling instructions. The engine holds 1.5 litres (1.6 USqt) 100 hours of running time. When operating with a heavy load or at seal on the new oil filter using new oil. Fit the oil filter
  • Husqvarna R 322T AWD | Owners Manual - Page 33
    necessary with engine oil SAE 10W/40 (class SF-CC). Rider 322T AWD Fill if necessary with oil Synthetic 10W/50 The oil and filter should be changed by an authorised service representative, as described in the Workshop Manual. Work on the system entails particular demands on cleanliness and the system
  • Husqvarna R 322T AWD | Owners Manual - Page 34
    Troubleshooting schedule Problem Procedure Engine does not start There fuel line Choking or incorrectly adjusted throttle cable Engine seems to have no power Air filter clogged Spark plug defective Dirt in the carburettor or fuel -speeding Engine speed too low Drive belt slipping English - 34
  • Husqvarna R 322T AWD | Owners Manual - Page 35
    use petrol for cleaning purposes. Use degreasing agents and hot water instead. To prepare the machine for storage follow these instructions: parts state your machine's purchase year, model, type, and serial number. Always use genuine parts. Annual inspection or tuning by an authorised service
  • Husqvarna R 322T AWD | Owners Manual - Page 36
    Rider 220T Rider 322T AWD Length without cutting unit, mm/ft 2020/6,61 2020/6,61 Width without cutting unit, mm/ft 890/2,92 890/2,92 Height, mm/ft 1150/3,77 1150/3,77 Operating Combi 112 Combi 112 SD 48 SD 48 Note 1: The power rating of the engine indicated is the average net output (
  • Husqvarna R 322T AWD | Owners Manual - Page 37
    25-75/0.98-2.95 423 / 16,7 IMPORTANT INFORMATION When the service life of this product has been served and it is no longer used it should be returned to the dealer or to an applicable basis of information in this manual. Use only genuine parts for repairs. The warranty is not valid if non genuine
  • Husqvarna R 322T AWD | Owners Manual - Page 38
  • Husqvarna R 322T AWD | Owners Manual - Page 39
  • Husqvarna R 322T AWD | Owners Manual - Page 40
    Original instructions 1154551-95 ´´®®zz++VVWW,,¶¶66%%¨¨ 2012-05-04
  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
  • 40
English
Rider 220T
Rider 322T AWD
Oper
ator
′
s manual
Please r
ead the operator’s manual carefully and make sure you
understand the instructions before using the machine.