Husqvarna RZ4824F Owners Manual - Page 33
Manual Transport, Integrated Zeroturn Transaxle bYpass linkages.
View all Husqvarna RZ4824F manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 33 highlights
operation Manual Transport When pushing or pulling the mower, engage the EZT (Integrated Zeroturn Transaxle) bypass linkages. The EZT bypass linkages are located on the rear of the frame, below the rear engine guard. 1. Raise the deck into the highest cutting position. 2. Pull the EZT bypass linkages up and out of the keyhole slots. Release the levers with the head outside the frame and held in the bypass position. 3. To reengage the EZT's to drive, reverse the above procedure. Load the machine into truck or trailer by driving up ramps in low gear. DO NOT LIFT! The machine is not intended to be lifted by hand. Bypass linkage, EZT engaged WARNING! Make no adjustments without: • the engine stopped, • the ignition key removed, • the parking brake activated 8058-032 8058-033 Bypass linkage, EZT locked in the bypass position 33