Husqvarna Z146 Owner Manual - Page 15
Fuse, Seat Adjustment Lever, Fuel Shut Off Valve, Cutting Height Lever, Bypass Linkages
View all Husqvarna Z146 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 15 highlights
CONTROLS Fuse Cutting Height Lever The 20 amp primary fuse is located on the left hand side of the machine. It is accessed by tilting the seat forward. The fuse is a flat pin type used in automobiles. To set the deck cutting height, pull the cutting height lever inwards and move it to the desired height notch. IMPORTANT INFORMATION Always raise the deck to the highest position for transport. Seat Adjustment Lever IMPORTANT INFORMATION To obtain an even cutting height, it is important that the air pressure in all tires is 15 psi / 103 kPa / 1 bar. Bypass Linkages The seat can be adjusted lengthways. When making adjustments, the lever below the right side of the seat is pulled up, after which the seat can be moved backward or forward. Fuel Shut Off Valve Transaxle bypass linkages must be engaged when pushing or pulling the mower. The release levers are located on each side of the rear of the unit below the rear engine guard. See Moving Machine By Hand in the Operation section. WARNING! Bypass linkages are located close to the muffler. To prevent burns, the engine should be shut off and allowed to cool before the bypass linkage levers are handled. The fuel shut off valve is located at the right rear of the seat. The valve is off when the handle tab is turned perpendicular to the fuel line. 15