Husqvarna Z554L Owner Manual - Page 15

CONTROLS Seat Adjustment Cutting Height The seat can be adjusted lengthways with the lever located at the right hand side of the seat. When making adjustments the lever is moved upward. Adjustments may be made to seat suspension by turning the center knob. IMPORTANT INFORMATION Seat must not be adjusted while unit is in motion. Seat Release The cutting height pedals release the deck lift and set the desired deck height. Apply pressure to the lift pedal (lower) and rotate foot to also apply pressure to the release pedal (upper), unlocking the deck lift. For transport, push the lift pedal forward until the deck lift latches in the transport (highest) position. The cutting height can be set from 1"- 5" (25.4 mm - 127 mm. To set the deck cutting height, press the button on the top of the height pin to remove it. Slip the height pin into the hole for the desired cutting height. Release deck height control pedal by pushing it forward. IMPORTANT INFORMATION Always raise the deck to the highest position for transport. Fuel Tanks The seat can be rotated forward to access the mower battery and hydro gears. Push down on the latch lever to release the seat. Raise the seat until the rod engages. Fuses Read the safety instructions before refueling. The capacity for each tank is 6 gallons (22.7 liters). Regularly check the gas cap gasket for damage and keep the cap properly tightened. Fuses are located on the left hand side of the machine and are accessed by tilting the seat forward. Fuses are flat pin fuses type as used in automobiles. The 20 A is the primary fuse. The 7.5 A is for the mower deck coupling. The 10 A is for accessories. WARNING! Fill to bottom of filler neck. Do not overfill. Wipe off spilled oil or fuel. Do not store, spill or use gasoline near an open flame. The engine will run on a minimum of 87-octane unleaded gasoline (no oil mix). Environmentally adapted alkylate gasoline can be used. See 15