Husqvarna Z554L Owner Manual - Page 18
Running, Stopping the Engine, Operating on Hills
View all Husqvarna Z554L manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 18 highlights
O P E R AT I O N 5. Move throttle control to the middle position. If the engine is cold, pull the choke control up. 2. Release deck height control by applying equal pressure to the two pedals. Push pedals again to lower deck to selected setting. 3. Move throttle control to full throttle. 4. Engage the mower deck by pulling the blade switch up. WARNING! Make sure that no one is near mower when engaging blade switch. 6. Set the fuel tank valve to the desired tank. 7. Set the deck height pin in the desired position. 8. Press in and turn the ignition key to the start position. IMPORTANT INFORMATION Do not run the starter for more than five seconds each time. If the engine does not start, wait approximately ten seconds before retrying. 9. When the engine starts, immediately release the ignition key back to the run position. Slowly push in the choke control knob, if it was used to start a cold engine. 10. Set the engine speed with the throttle. Allow the engine to run at a moderate speed, approximately mid throttle, for a short time before use. USE FULL THROTTLE WHEN MOWING (no choke). Running 1. Release the park brake by pulling the steering / park brake controls in to the neutral position at the same time. NOTE: The mower is equipped with an operator presence system. If the operator tries to leave the seat with the engine running, without first engaging the park brake, the engine will shut off. 5. Pull control levers inward and slowly move the two control levers slightly forward to move forward in a straight line. Stopping the Engine 1. Move the throttle to the minimum position (tortoise symbol). 2. Move the steering / park brake controls at the same time out to the park brake position. 3. Release the mower deck by pressing the blade switch down. 4. Raise the mower deck by pressing the foot pedals forward to the transport position. If the engine has been worked hard, allow it to idle at least sixty seconds to attain a normal operating temperature before stopping. To prevent fouling the spark plugs, avoid idling the engine for longer periods. 5. Turn the ignition key to the stop position and remove the key. Always remove the key when leaving the mower to prevent unauthorized use. IMPORTANT INFORMATION When stopping and leaving the machine, the two steering / park brake controls must be moved out to the locked position at the same time. IMPORTANT INFORMATION Leaving the ignition switch in a position other than OFF will cause the battery to be discharged. Operating on Hills Read the Safety Instructions Driving on Slopes in the Safety section. • Use the slowest speed possible before starting up or down hills. • If stopping is fully necessary, pull steering / park brake controls into the neutral position and push outward to engage the park brake. • Pull the steering / park brake controls back to the center of the mower and push forward to regain forward movement. • Try not to stop or change speed on hills. • Make all turns slowly. 18