IBM 3580-H23 Setup Guide - Page 104
Unloading the Cartridge from the Drive, s loader so
View all IBM 3580-H23 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 104 highlights
Unloading the Cartridge from the Drive 1. With the small-blade screwdriver, continue to rotate the loader motor gear in the unload direction (counterclockwise) (see 1 in Figure 26 on page 87). The cartridge moves slowly out of the tape load compartment. 2. Remove the tape cartridge. 3. To reuse the 3580 Ultrium 2 Tape Drive, you must raise the drive's loader so that it is able to accept a cartridge. To raise the loader, continue to wind the loader motor gear counterclockwise with the screwdriver until you feel resistance. 4. Remove the small-blade screwdriver. 5. To reassemble the 3580 Ultrium 2 Tape Drive, reverse the preceding steps. 88 IBM 3580 Ultrium Tape Drive Setup and Operator Guide
Unloading the Cartridge from the Drive
1.
With the small-blade screwdriver, continue to rotate the loader motor gear in
the unload direction (counterclockwise) (see
±1²
in Figure 26 on page 87). The
cartridge moves slowly out of the tape load compartment.
2.
Remove the tape cartridge.
3.
To reuse the 3580 Ultrium 2 Tape Drive, you must raise the drive
’
s loader so
that it is able to accept a cartridge. To raise the loader, continue to wind the
loader motor gear counterclockwise with the screwdriver until you feel
resistance.
4.
Remove the small-blade screwdriver.
5.
To reassemble the 3580 Ultrium 2 Tape Drive, reverse the preceding steps.
88
IBM 3580 Ultrium Tape Drive Setup and Operator Guide