IBM 867282X Installation Guide - Page 25

Installing the cover, your server documentation for instructions.

Get IBM 867282X - Eserver xSeries 300 PDF manuals and user guides
UPC - 087944650966
View all IBM 867282X manuals
Add to My Manuals
Save this manual to your list of manuals

Page 25 highlights

Installing the cover Complete the following steps to install the server cover: 1. Install the cover by placing it into position and sliding it forward. Make sure that the cover engages the tabs at the front and rear of the server. Attention: Before sliding the cover forward, make sure that all of the tabs on the cover will engage the ledge at the front of the server properly. If all the tabs do not engage the ledge properly, it will be extremely difficult to remove the cover later. Screws 2. Install the screws to secure the cover as shown. 3. Install the server in the rack. See the "Rack installation instuctions" included with your server documentation for instructions. 4. Connect the power cord and all external cables to the server, and then plug the power cords into properly grounded electrical outlets. See "Working with cables" on page 14 for connector locations. Chapter 2. Installing Options 13

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
  • 40
  • 41
  • 42
  • 43
  • 44
  • 45
  • 46
  • 47
  • 48
  • 49
  • 50
  • 51
  • 52
  • 53
  • 54
  • 55
  • 56
  • 57
  • 58
Chapter 2.
Installing Options
13
Installing the cover
Complete the following steps to install the server cover:
1.
Install the cover by placing it into position and sliding it forward. Make sure that
the cover engages the tabs at the front and rear of the server.
Attention:
Before sliding the cover forward, make sure that all of the tabs on the
cover will engage the ledge at the front of the server properly. If all the tabs do not
engage the ledge properly, it will be extremely difficult to remove the cover later.
2.
Install the screws to secure the cover as shown.
3.
Install the server in the rack. See the "Rack installation instuctions" included with
your server documentation for instructions.
4.
Connect the power cord and all external cables to the server, and then plug the
power cords into properly grounded electrical outlets. See “Working with cables”
on page 14 for connector locations.
Screws