Icom IC-A6 Instruction Manual - Page 19

MEMORY OPERATION 4 I Memory names ï Programming memory names Key Character Key Character Key Character The memory channel can display a 6-character names instead of the programmed frequency. 1 1, Q, Z 2 2, A, B, C 3 3, D, E, F 4 4, G, H, I 5 5, J, K, L 6 6, M, N, O 4 q Rotate [DIAL] to select the desired frequency in the frequency mode. w Push , then push [MR•MW] to program the contents into the selected memory channel. e Rotate [DIAL] to select the desired memory channel to be programmed. • Push [0•BANK] to select the BANK number if desired. Push [CLR•DEL] to exit the BANK selection mode. r Push [MR•MW] to enter the memory name programming mode appears on the display. t Push the appropriate digit key several times to select the desired character as listed at right. • To erase a character, overwrite with a space (displayed as _). • To move the cursor forwards or backwards, use [DIAL]. y Push [ENT•WX] to program the name. • Flashing the memory name stops. • When no name is programmed, the display shows the operating frequency. • To clear the programmed memory names, push [CLR•DEL] before pushing [ENT•WX]. 7 7, P, R, S ENT Program 8 8, T, U, V 9 9, W, X, Y 0 0, space, - I Clearing the memory contents Unwanted memory channels can be cleared. Programming over a memory channel also clears the previously programmed contents. Memory channel 1 cannot be cleared. q Select the memory channel to be cleared. w Push , then push and hold [CLR•DEL] for 1 sec. appears momentarily, then the next selectable channel appears. 14