Image Fitness Renew 400 Canadian English Manual - Page 12

Console Diagram Thermostat On/Off Button Air Control USING THE CONSOLE Refer to the diagram above. The function of each console control is explained below: Thermostat: Controls the temperature of the water. The water heats at about 1.8°F (2°C) per hour with the cover on. The thermostat can be set to heat the water from 70°F to 104°F (21°C to 40°C). Use a medical thermometer or other accurate thermometer to check the temperature of the water. Note: The hydrotherapy spa offers an automatic freeze protection. If the water temperature falls below 40°F (4°C), the pump will begin circulating the water to prevent the water from freezing. On/Off Button: Turns the spa on and off. When you first press the on/off button, the spa jet unit will run at low speed, providing gentle hydrotherapy. Press the button again and the spa will run at high speed, providing more intense hydrotherapy. Press the button a third time and the spa will shut off. The spa also features an automatic mode that heats and filters the water when the spa is left unattended. When the spa is first plugged in, or if the buttons on the console have not been used for longer than twenty minutes, the automatic mode will begin filtering or heating the water, as needed. Note: To keep the filter and heat cycles from running, The GFCI or breaker must be shut off. Air Control: Determines the amount of air that is in the spa jet system during operation. If the control is turned to the left, the amount of air flowing through the jets will increase. If the control is turned to the right, the amount will decrease. 12